Cobra Electronics FRS237 - Manuel (Page 6)

Mode Button
Channel Button
Customer Assistance Warranty Introduction
9 Nothing comes close to a Cobr a ™
Operation
Call Button
•
T o Alert Another Person That You Are Calling:
1. Press and release the Call button.
The other person will hear a two (2) second call
tone. You cannot send or receive transmissions
during the two (2) second call tone.
See page 11 on how to select
between ten (10) call tone settings.
Scan
•
Y our microTALK ® radio can automatically scan
main channels (1 through 14) or the privacy codes
(00 through 38) within one (1) main channel.
T o Scan Main Channels:
1. Press the Mode button until the Scan icon and
the main channel number flashes on the display.
2. Press the Channel Up or Channel Down button
to begin scanning the main channels.
The radio ignores privacy codes
while scanning main channels.
3. The Scan icon will continue to be displayed
when Scan is On. Your radio will continue to
scan all main channels and stop if an incoming
transmission is detected.Your radio will remain
on that channel for ten (10) seconds. During this
time, you can:
a. Press and hold the T alk button and
communicate with others. Your radio
will remain on that channel and return
to
Standby Mode.
b. Press the Channel Up or Channel Down
button to r esume scanning channels.
c. Press the Mode button to pr oceed to
privacy code scanning (see page 10 for
further details).
8 English
Using Your Radio
Operation
T o Select a Privacy Code:
1. After selecting a channel, press the Mode
button until the small numbers next to the
channel number flash on the LCD.
2. Press the Channel Up or Channel Down button
to select a privacy code. You can hold the Up
or Down button for fast advance.
3. When your desired privacy code is displayed:
a. Press the Mode button to enter the new
setting and proceed to other functions.
b. Press the Lock button to enter the new
setting and return to Standby Mode.
c. Do not press any buttons for 15 seconds
to enter the new setting and return to
Standby Mode.
Listening for a Response
•
When Y ou are Finished Talking:
1. Release the T alk button to r eceive incoming
transmissions. Your microTALK ® radio is
always in Standby Mode while the T alk or
Call buttons ar e not pressed.
V olume
•
T o Adjust the Volume:
1. Press the V olume Up or V olume Down button.
A double beep sound is used to indicate
the minimum and maximum volume levels
(L1 through L7).
Listening
Call Button
Volume Button
Volume Level
Privacy Code
Mode Button
Channel Button
Scanning Channels