Cobra Electronics FRS237 - Manuel (Page 4)

Operation Customer Assistance Warranty
5 Nothing comes close to a Cobr a ™
Introduction
Caring for Y our microTALK ® Radio
•
Y our microTALK ® radio will give you years of trouble-free service if
cared for properly. Handle the radio gently. Keep the radio away from
dust. Never put the radio in water or in a damp place. Avoid exposure
to extreme temperatures.
Batteries
•
T o Install or Replace Batteries:
1. Remove belt clip by releasing belt clip
latch and sliding clip up.
2. Pull down on the Batter y Door Latch to
remove the battery compartment cover.
3. Insert four (4) AAA batteries. (Always use high
quality alkaline batteries.) Position batteries
according to polarity markings.
4. Replace Battery Compartment cover and belt clip.
Contact your local Cobra ® dealer or
Cobra ® directly for optional battery
pack and desktop charger accessories.
Insert Batteries
Pull Down Lock Latch
Remove Belt Clip
The Basics to Get You Started
Your microTALK
® radio is easy to use.
To get started, simply:
1. Press the Power button to turn On your radio.
2. Press the Channel Up or Channel Down
button to select a channel.
Both radios must be tuned to the
same channel to communicate.
3. Press and hold the Talk button while
speaking into the microphone.
4. When finished talking, release the Talk
button and listen for a response.
4 English
Product Features
Introduction
Backlit LCD
Display
Lock
Icon
Roger
Beep Icon
Receive/Transmit
Tower Icon
Battery
Low
Main Channel
Numbers
Power
Saver Icon
CTCSS Privacy
Code Numbers
Scan Icon
Features
• Two-Way Radio
W ith a range
up to three (3)
kilometers
(2 miles).
• 14 Channels
• 38 Privacy Codes
• Backlit LCD
Display
• Scan
(channel,
privacy code)
• Water Resistant
• Speaker/
Microphone Jack
• Call Alert
(10 selectable
tones)
• Lock
• “Roger Beep”
(selectable On/Of f)
• Battery/
Power Saver
• Auto Squelch
• Maximum
Range Extender
• Belt Clip
• Wrist Strap
Industry Canada Notice: Operation is subject to the following two (2)
conditions: 1) this device may not cause interference, and 2) this device
must accept any interference, including interference that may cause
undesired operation of the device.
«IC» before the equipment certification number signifies that the Industry
Canada technical specifications were met. It does not guarantee
that the certified product will operate to the user’s satisfaction.
Important FCC Licensing Information
This device complies with part 15 of the FCC Rules. Operation is subject
to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
FCC W arnings: Replacement or substitution of transistors, regular diodes or
other parts of a unique nature, with parts other than those recommended by
Cobra
® , may cause a violation of the technical regulations of part 95 of the FCC
Rules, or violation of Type Acceptance requirements of Part 2 of the Rules.