Press push to start to begin cycle, Set temperature and options (on some models), Select end of cycle signal (if desired) – Crosley W10096992A Manuel d'utilisation

Page 8: Drying rack (optional on some models)

Advertising
background image

8

6.

Press PUSH TO START to

begin cycle

Push and hold the PUSH TO START knob to begin the cycle.
Promptly remove garments after cycle has completed to reduce

wrinkling. Use the Wrinkle Prevent feature to avoid wrinkling

when you are unable to remove a load from the dryer as soon

as it stops.

4.

Set temperature and options

(on some models)

Select temperature and options by turning the knob to the

desired position or select the Automatic Dry Cycle that has the

temperature included in the cycle selections.
NOTE: Not all options and settings are available with all cycles.
TEMPERATURE
Turn the TEMPERATURE knob to change the drying

temperature setting. See “Setting the Drying Temperature.”
Wrinkle Prevent feature (on some models)

n

Get up to 90 minutes of heat-free, periodic tumbling at the

end of a cycle. Turn the WRINKLE PREVENT knob to select

ON or OFF at any time before the cycle has ended.

5.

Select End of Cycle Signal

(if desired)

Turn the END OF CYCLE SIGNAL knob to select the desired

setting (On or Off). The End of Cycle Signal produces an

audible sound when the drying cycle is finished. Promptly

removing clothes at the end of the cycle reduces wrinkling.
NOTE: When the Wrinkle Prevent setting is selected and the

End of Cycle Signal is on, the tone will sound every 5 minutes

until the clothes are removed, or the Wrinkle Prevent setting

ends.

Drying Rack (optional on some models)

Use the Drying Rack to dry items such as sweaters and

pillows without tumbling. The drum turns, but the drying

rack does not move.
If your model does not have a drying rack, you may be

able to purchase one for your model. To find out whether

your model allows drying rack usage and for information

on ordering, please refer to the “Accessories” section

or contact the dealer from whom you purchased your dryer.
NOTE: The drying rack must be removed for normal

tumbling.
To use the drying rack
1.
Place drying rack in dryer.

Slide rear pegs into the dimples on the back wall of the

dryer. Lower the front legs to rest on the dryer opening.

2. Put wet items on top of drying rack, leaving space

between items. Do not allow items to hang over the

edge of the drying rack. Close the door.

3. Select a Timed Dry cycle and temperature, or an air

cycle (on some models). Items containing foam, rubber,

or plastic must be dried on a clothesline or by using an

air cycle. Refer to the following table.

4. Start the dryer. Reset cycle to complete drying, if needed.

Rack Dry:

Temp.

Cycle:

Time

Washable wool items (block to

shape, lay flat on drying rack)

Stuffed toys/pillows (foam rubber

filled) (on some models)

Timed

Dry

Air

(no heat)

N/A

60 min.

90 min.

Low

Stuffed toys/pillows (cotton or

polyester filled)

Timed

Dry

Low

60 min.

Advertising
Ce manuel est liée aux produits suivants: