Troubleshooting cont, Accessories – Crosley W10096992A Manuel d'utilisation

Page 12

Advertising
background image

12

First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions)

to possibly avoid the cost of a service call.

If you experience

Possible Causes

Solution

TROUBLESHOOTING cont.

Cycle time too short

Sensor cycle ending early.

The load may not be contacting the sensor strips. Level the

dryer.

Use Timed Dry for very small loads. Change the Dry Level

setting on Sensor Dry/Auto Dry cycles.

Increasing or decreasing the Dry Level setting will change the

amount of drying time in a cycle.

Lint on load

Lint screen clogged.

Lint screen should be cleaned before each load.

Stains on load or drum

Dryer fabric softener not properly

used.

Add dryer fabric softener sheets at the beginning of the cycle.

Fabric softener sheets added to a partially dried load can stain

your garments.
Drum stains are caused by dyes in clothing (usually blue jeans).

These will not transfer to other clothing.

Loads are wrinkled

Load not removed from dryer at the

end of the cycle.

Select Wrinkle Prevent feature to tumble the load without heat

to avoid wrinkling.

Dryer tightly packed.

Dry smaller loads that can tumble freely to reduce the chance

of wrinkles forming.

Odors

You have recently been painting,

staining, or varnishing in the area

where your dryer is located.

Ventilate the area. When the odors or fumes are gone from the

area, rewash and dry the clothing.

The electric dryer is being used for

the first time.

The new electric heating element may have an odor. The odor

will be gone after the first cycle.

Load is too hot

Laundry items were removed from

the dryer before the end of the

cycle.

Allow Cool Down cycle to finish before removing laundry from

dryer. All cycles are cooled slowly to reduced wrinkling and

make it easier to handle. Items removed before Cool Down may

feel very warm.

A high temperature cycle was used

or TEMPERATURE control was set

to high.

Select a lower temperature, and use a Sensor Dry/Auto Dry

cycle. These cycles sense the temperature or the moisture level

in the load and shut off when the load reaches the selected

dryness. This reduces overdrying.

Enhance your dryer with these premium accessories.
For more high-quality items or to order, call

1-800-901-2042,

or visit us at

www.applianceaccessories.com. In Canada,

call

1-800-807-6777 or visit us at www.whirlpoolparts.ca.

Part Number

Accessory

3404351

Drying rack – fits 29" (737 mm) Super

Capacity, 6.5 cu. ft. (0.18 cu. m) –

side swing or hamper door

3406839

Drying rack – fits 29" (737 mm) Super

Capacity Plus, 7.0 cu. ft. (0.20 cu. m) –

side swing door only

ACCESSORIES

Advertising
Ce manuel est liée aux produits suivants: