Petsafe Comfort Fit In-Ground Fence Kit - Manuel (Page 8)

8 www.petsafe.net
Additional Boundary Wire
We recommend the use of 20 gauge
insulated multi-strand copper wire for
direct burial. Extra Boundary Wire can
be purchased in 150 m (500 ft) spools
at the store where you purchased the kit
or through the Customer Care Centre.
Note: When adding Boundary Wire, it must
act as a continuous loop.
The table on the right indicates the
approximate length of Boundary Wire
needed for a rectangular, Single Loop
layout. Length will vary due to the
amount of twisted wire and layout used.
Area to
be enclosed
Approximate wire
length required
Ares Acres Metres Feet
10 1/4 127 415
13 1/3 146 480
20 1/2 180 590
40 1 255 835
80 2 360 1180
200 5 570 1870
400 10 854 2800
__________________________________________________
Connect the Wires to the Fence Transmitter
Boundary Wire (4A)
1. Run the Boundary Wire to the Fence Transmitter through a window, under a door,
through a crawl space vent, or any other appropriate available access. You can also drill
a hole through your wall.
2. Strip the ends of the Boundary Wire approximately 1.3 cm (1/2 in).
3. Insert the Boundary Wires into the Boundary Wire Terminals on the Fence Transmitter.
4. Turn the Boundary Width Control knob to 10. This will set the Warning Zone at the
maximum width.
5. Plug the Power Adapter into the Power Socket and a working outlet. The Power Adapter
comes with the North American tip installed and additional tips for the UK and Europe.
To change the tip:
a. Push in the tab on the Power Adapter and remove the tip by sliding it off as shown (4B).
b. Slide the proper tip for your electrical outlet onto the Power Adapter as shown (4C).
6. The Power Light and Loop Indicator Lights should come on. If this does not happen,
see the “Troubleshooting” section.
Boundary Control Switch
Boundary Wire
Terminals
Loop Indicator Light
Power Light
Power
Jack
Boundary Width
Control
4A 4B 4B
Step
4