Petsafe Comfort Fit In-Ground Fence Kit - Manuel (Page 19)

www.petsafe.net 19
Locating a Break in the Boundary Wire
Please follow these steps in determining where you have a break in your Boundary Wire:
1. Locate your original splice(s) and verify that they have a good, solid connection.
2. Check your property to determine any possible damage to the Boundary Wire (e.g. recent
digging, aerating, rodent burrowing, or any other noticeable disturbance in your property next
to the Boundary Wire).
If you still cannot fi nd the break in the Boundary Wire, follow the procedure below:
1. Unplug the Fence Transmitter.
2. Connect both ends of your twisted Boundary Wire to one
Boundary Wire Terminal.
3. Measure and cut a Test Wire that is half the length of your total
Boundary Wire footage.
4. Connect one end of Test Wire to the other Boundary Wire Terminal.
5. Locate the halfway point of your boundary and cut the Boundary Wire.
6. Splice the other end of the Test Wire to either side of your Boundary Wire
where you cut it in half.
7. Plug in the Fence Transmitter and check the Loop Indicator Light. If the
Loop Indicator Light is on, you can assume the break is in the other half
of the Boundary Wire.
Test
Wire
8. If the Loop Indicator Light does not come on, you may assume there is a break in this portion
of the Boundary Wire. However, there is a small chance of having more than one break in your
system. Be sure to check both halves of your entire loop.
9. Replace the damaged Boundary Wire with new Boundary Wire.
10. Reconnect the Boundary Wire to the Fence Transmitter.
11. Check the Loop Indicator Light. If the Loop Indicator Light is on, test the system
with the Receiver Collar.
_______________________________________________________
Terms of Use and Limitation of Liability
1. Terms of Use
This Product is offered to you conditioned upon your acceptance without modification of the terms,
conditions and notices contained herein. Usage of this Product implies acceptance of all such terms,
conditions, and notices.
2. Proper Use
This Product is designed for use with pets where training is desired. The specific temperament
of your pet may not work with this Product. We recommend that you do not use this product
if your pet is less than 3.6 kg (3.63 kg) or if your pet is aggressive. If you are unsure whether
this is appropriate for your pet, please consult your veterinarian or certified trainer.
Proper use includes reviewing the entire Guide provided with your Product and any specific
Caution statements.
3. No Unlawful or Prohibited Use
This Product is designed for use with pets only. This pet training device is not intended to harm,
injure or provoke. Using this Product in a way that is not intended could result in violation
of national or local laws.
4. Limitation of Liability
In no event shall Radio Systems Corporation be liable for any direct, indirect, punitive, incidental,
special or consequential damages, or any damages whatsoever arising out of or connected with the
use or misuse of this Product. Buyer assumes all risks and liability from the use of this Product.
5. Modification of Terms and Conditions
Radio Systems Corporation reserves the right to change the terms, conditions and notices
under which this Product is offered.