Thetford N84 Series Owner's Manual - Current - Manuel (Page 6)

Owner’s Manual 6
- Push and hold the MODE button until the light bar beside LP
GAS shows.
- This means that the refrigerator is operating on propane
gas.
- If the air in the propane gas supply lines prevents the
burner from ignition on propane gas, the fault code “F”
will appear in the center display.
- Push and hold the ON / OFF button for one second and
then release to turn the refrigerator off.
- Push the ON / OFF button to turn the refrigerator on.
- The refrigerator will start a 30 second trial for ignition.
- During the 30 second trial for ignition, the
refrigerator controls open the gas safety valve and
the igniter sparks.
- After 30 seconds, the refrigerator controls closes the
gas safety valve and the igniter stops sparking.
- When the light bar beside the LP GAS [6] shows and no fault
code remains, this means that the refrigerator is operating
on propane gas.
- At this time, all of the air is removed from the propane
gas supply lines and you may select AUTO mode of
operation if you wish.
- Depending on how much air may be in the propane gas
supply lines, you may need to repeat the 30 second trial for
ignition two or three times.
- If the burner does not ignite on propane gas after two or
three attempts, stop and consult your local dealer or an
authorized Norcold Service Center.
Set the controls to automatic mode operation:
- Push the ON / OFF button to turn the refrigerator on.
- Push and hold the MODE button until the light bar shows
beside AUTO [34] and then release.
- If 120 volts AC is available to the refrigerator:
- The light bar beside AC [4] also shows in the center
display.
- After ten seconds, the light bar beside AC goes off and
only the light bar beside AUTO remains.
- This means that the refrigerator is operating on AC
electric.
- If 120 volts AC is not available to the refrigerator:
- The light bar beside AC [35] also shows in the center
display.
- After a few seconds, the light bar beside AC goes off and
the light bar beside LP GAS [36] shows.
- After 10 seconds, the light bar beside LP GAS goes off
and only the light bar beside AUTO remains.
- This means that the refrigerator is operating on propane
gas.
If an energy source is available to the refrigerator, but is not
operating correctly:
- A fault code shows in the center display.
- The refrigerator controls try to change to a less efficient
energy source.
- If a less efficient energy source is not available:
- A fault code shows in the center display.
- Refer to the “Fault Codes” section of this manual.
Set the controls to manual mode operation:
- Push the ON / OFF button to turn the refrigerator on.
- Push and hold the MODE button until the light bar shows
beside AC [35] and then release.
- This means that the refrigerator is operating on AC
electric.
- Push and hold the MODE button until the light bar shows
beside LP GAS [36] and then release.
- This means that the refrigerator is operating on propane
gas.
If the energy source is interrupted:
- A fault code shows in the center display.
- Refer to the “Fault Codes” section of this manual.