Thetford N84 Series Owner's Manual - Current - Manuel (Page 14)

Owner’s Manual 14
Replacement Parts
You may purchase replacement parts through your local RV
dealer or authorized Norcold Service Center.
Reinstall the Refrigerator
Your dealer or Norcold authorized service center must do this
procedure.
WARNING: Make sure the combustion seal is not
broken, is completely around the refrigerator mounting
flanges, and is between the mounting flanges and the wall
of the enclosure. If the combustion seal is not complete,
exhaust fumes can be present in the living area of the
vehicle. The breathing of exhaust fumes can cause
dizziness, nausea, and in extreme cases, death.
1. Push the refrigerator completely into the enclosure.
2. Install the screws in the upper and then the lower mounting
flanges on the front of the refrigerator.
3. Install the screws in the mounting flange at the rear of the
refrigerator.
4. Put the plastic plugs into the mounting flanges of the
refrigerator.
WARNING: To avoid possible propane gas leaks, always
use two wrenches to loosen and tighten the gas supply
line connections.
5. Attach the gas supply line to the bulkhead fitting of the
refrigerator.
6. Open the valve at the propane gas tank(s).
WARNING: Do not allow the leak checking solution
to touch the electrical components. Many liquids are
electrically conductive and can cause electrical shorts and
in some cases, fire.
7. Examine the gas supply line for leaks.
8. Connect the DC wiring to the refrigerator:
- Connect the DC wires to the refrigerator.
- Install the DC fuse or connect the DC wiring to the battery or
the converter.
9. Connect the black AC power cord and the white ice maker AC
power cord (model N843-IM only) to the receptacle.
!
!
!
Ice Maker Wiring Pictorial and Diagram
(N64XIM, N64XIMXX, N84XIM, and
N84XIMXX models)
The parts of the ice maker wiring pictorial and diagram are (See
Art01500):
120V AC Hot .............................................................................109
PC Board ....................................................................................49
Ground screw ........................................................................... 111
Hot / smooth ............................................................................. 112
Neutral / Ribbed........................................................................ 113
Solenoid Water Valve .................................................................44
Thermal Fuse ........................................................................... 114
Ice maker .................................................................................. 115
Mold Heater .............................................................................. 116
Thermostat .................................................................................96
Shut Off Switch ......................................................................... 117
Fill Switch ................................................................................. 118
Holding Switch .......................................................................... 119
Motor ........................................................................................120
120V AC Neutral ....................................................................... 110
Wiring Diagram and Pictorial
The parts in the wiring pictorial are (See Art01875):
The parts in the wiring diagram are (See Art01876):
A .....................................................................................AC heater
B ............................................................................................. Light
C ....................................................................................Thermister
D .....................................................................................Gas valve
E ...........................................................................................Igniter
F ...............................................................................Divider heater
G ......................................................Temperature switch (optional)
H ......................................................Temperature switch (optional)
I.................................................................................Fan (optional)
J ...........................................Ice maker water line heater (optional)
K .....................................................................DC heater (optional)
L .............................................................................Chassis ground
M ......................................................................DC board (optional)
N .................................................................................. Door switch
P ......................................................................Temperature switch
1..........................................................................Switched 12 VDC
2............................................................Fused continuous 12 VDC
3........................................................................... Communications
4..............................................................................Display ground
5............................................................................ Auxiliary ground
6.........................................................................Auxiliary +12 VDC
7...........................................................................Divider +12 VDC
8...................................................................... Gas valve +12 VDC
F1 ...........................................................................5 Amp fuse DC
F2 ........................................................................... 8 Amp fuse AC
F3 .........................................................................30 Amp fuse DC