Thetford N1095 Series Installation Manual - Current - Manuel (Page 8)

Installation Manual 8
- If the depth of the enclosure is more than 26 inches, install a wood or an aluminum or galvanized sheet solid box baffle [21] in the
rear of the enclosure (See Art01681 and Art01682).
- Make sure that the bottom of the solid box baffle is 18 inches to 18 1/2 inches above the bottom of the enclosure [17] (4 1/4
inches to 4 3/4 inches above the top of the lower intake vent opening REF) [18] .
- Make sure that the back of the solid box baffle is perpendicular to the bottom of the enclosure.
- Make sure that the back of the solid box baffle is either against the top of the enclosure or against the angled baffle [13]
(depending on the vehicle design).
- Make sure that the solid box baffle is one inch or less [19] from the coils [10] and condenser of the refrigerator.
- Make sure that the solid box baffle is the full width of the inside of the enclosure.
Art01681
14
15 13
12
19
11
21
18
17 10
9
Art01682
14 20
12
13
11
19
21
18
17
10
9