Thetford N1095 Series Installation Manual - Current - Manuel (Page 10)

Installation Manual 10
Reverse the Door Swing-Nonmetal Doors (optional)
This refrigerator has cabinet hinges that allow you to change the direction the door opens by moving the hinges on a diagonal to the
opposite side. Reverse the door swing before installing the refrigerator in the vehicle.
1. Pull off both the upper [40] and lower [128] trim pieces if they are already
installed (See Art01688 and Art01689).
2. Remove the doors (See Art01731):
- Remove the storage bins from the doors.
Do not mix the upper and lower hinge pins because they are
different.
- Remove and save the upper hinge pin [63] from each door.
- Pull the door latch and remove each door from the refrigerator.
- Remove and save the lower hinge pin [5] from each
hinge.
- Make sure that the bend of the baffle is the full width of the inside of the enclosure.
- Make sure that the bend of the baffle is flush with the bottom edge of the upper intake vent door frame.
- Make sure that the top edge of the baffle is 1/4 inch [213] below the bottom of the condenser and that there is 1/4 inch or
less clearance [15] between the rear of the condenser and the baffle.
- If the depth of the enclosure is more than 26 inches [27], install a wood or an aluminum or galvanized steel sheet solid box
baffle [21] between the lower intake vent and the upper exhaust vent (See Art01680).
- Make sure that the solid box baffle is the full width of the inside of the enclosure.
- Make sure that the bottom of the solid box baffle is 18 inches to 18 1/2 inches above the bottom of the enclosure [17] (4
1/4 inches to 4 3/4 inches above the top of the lower intake vent opening REF) [18] .
- Make sure that the back of the solid box baffle is perpendicular to the bottom of the enclosure.
- Make sure that the horizontal top of the solid box baffle is even with the bottom edge of the upper exhaust vent [24].
- Make sure that the vertical top edge of the baffle is between 1/4 inch [213] below the condenser [3] and 1 1/2 inches
above the bottom of the condenser.
- Make sure that there is 1/4 inch or less clearance [15] between the rear of the condenser and the baffle.
211
41
128
208
Art01688
210
40
41
Art01689
NOTICE