Sony DVP-S500D - Manuel (Page 40)

Dolby Digital Surround
Setting for Dolby Digital
Surround^
To enjoy Dolby Digital Surround sound, set the output
signal from the 5.1 channel output connectors.
Note
To enjoy the original Dolhv Digital (AC-3) sound through the
5.1 OUTPUT connectors, do not set "DIGITAL OUT" to
"D-PCM" under "INITIAL SETUP 2" in the setup display. For
details, see page 35.
ENTER
■/♦/I-/-
1 Press SET UP and select 2 "/ then press ENTER.
2 Set "MODE" to the desired item.
• Those settings also affect the output from the LINE OUT
(AUDIO I, 2) connectors.
Notes
• When \'Ou select an item, the sound cuts off for a moment.
• When you select "PRO LOGIC", the sound ma\- only come
from the center speaker depending on the disc.
• When the playing signal does not contain the surround
component, the effects ma\’ be difficult to hear even if vou
select "PRO LOGIC", "VES A" or "VES B." In this case, set
this item to "OFF".
• If the sound distortion occurs when you select "PRO
LOGIC", "VES A" or "VES B," set this item to "OFF".
• If )'ou connect the front speakers only, there is no surround
effects even if vou select "PRO LOGIC."
• When you select "VES A" or "VES B," you cannot adjust
the level or the balance of the speakers except for the front
speakers.
• If both the front speakers are not placed an equal distance
from your listening position, the effects may be difficult to
hear even though you select "VES A" or "VES B."
• The setting "PRO LOGIC" affects only when:
- you play a CD/VIDEO CD
- you play the PCM sound track on a DVD
- you play the "DOLBY DIGITAL 2/0" sound track
on a DVD.
III.1 VES (Virtual Enhanced Surround) A
^ BSS1 rai2 4) 1 2
5. 1 OUTPUT SETUP 2
MODE:* OFF
TEST TONE: OFF
BALANCE m m m
FRONT 0. OdB
REAR
LEVEL
0. OdB
CENTER 0. OdB,^ h,
0. OdB ^ ^ REAR
SUBWOOFER
0. OdB
0000 *[H1 QUIT S
VES (Virtual Enhanced Surround) B
Default setting is "OFF."
■ MODE
• OFF : outputs all channel signals recorded on the DVD.
When you cormect fewer than 5 (+1) speakers, the player
distributes the output signal for the missing speaker to
other speakers appropriately.
When you play a CD or a VIDEO CD, outputs the stereo
signal to the front speakers.
• PRO LOGIC : outputs the Pro Logic processed signals when
the input signals àie stereo.
• VES A* : uses 3D sound imaging to create virtual rear
speakers from the sound of the front speakers (L, R)
without using actual rear speakers. The virtual speakers
are reproduced as shown in 111. 1.
• VES B* : uses 3D sound imaging to create virtual rear
speakers from the sound of the front speakers (L, R)
without using actual rear speakers. The virtual speakers
are reproduced as shown in 111. 2.
40 EN