Series ok3 – infrared radiant heaters, Renewal parts list / pièces de rechange, Description – CCI Thermal Technologies GX - Heavy Duty Forced Air Unit Heater Manuel d'utilisation

Page 4: Installation

Advertising
background image

MI182 REV.8 Page 1 of 2

CCI Thermal Technologies Inc. 2721 Plymouth Drive, Oakville, ON L6H 5R5 Tel. (905) 829-4422 Fax (905) 829-4430

www.ccithermal.com

ISO 9001:2000

INSTALLATION, OPERATION AND MAINTENANCE INSTRUCTIONS FOR

SERIES OK3 – INFRARED RADIANT HEATERS

FIRE/EXPLOSION HAZARD WARNING - During operation, take precautions to ensure that

combustible materials are always kept at a safe distance from the radiant energy. This heater is

not intended for use in hazardous areas where flammable vapours, gases or liquids or other

combustibles are present. Remember that objects placed under an infrared heater can take a while

to reach stabilized temperatures. If you are unsure of the suitability of the heater for the intended

application, check with the factory for recommendations. Failure to comply can result in personal

injury and/or property damage.

DESCRIPTION

1.0

The OK3 radiant heaters are suitable for comfort heating

use in non-hazardous areas protected from rain, snow or splashing,

where heating element temperatures in excess of 750°C(1382°F)

will not present the risk of fire or explosion. The heater does not

present a safety hazard when it is installed, operated and maintained

in accordance with these instructions.

2.0

The OK3 heater has two U-shaped metal sheath heating

elements factory interconnected in series or parallel depending on

voltage. Never change heaters which have been factory series

connected to a parallel connection.

3.0

Minimum space clearances from combustibles, when

heaters are horizontally mounted and installed, as listed in Table 1

following.

Table 1

Min. Spacing

From nearest wall

600 mm (24”)

From the ceiling

300 mm (12”)

INSTALLATION

The system designer is responsible for

the safety of this equipment and

adequate back-up controls and safety

devices must be installed. Failure to

comply could result in personal injury

and/or property damage.

Heaters must be wired by qualified

personnel in compliance with local

codes.

5.0

Verify that the nameplate voltage and wattage are suitable

for use on the available electrical power supply. Do not connect

the heater to an electrical supply voltage other than shown on the

product label.

Insulation contamination or moisture

accumulation can cause fault to the

element sheath generating arcing and

releasing molten metal. Install proper

ground fault protection to prevent

personal injury and/or property

damage.

6.0

The connection box volume is 3100 cm³(190 in³).

7.0

Supply conductors to the heater must be suitable for

110°C(230°C). The ground wire from the supply shall be connected

to the grounding connection located in the connection box.

8.0

The connection box has eight dual knockouts, ½" or ¾"

and two dual knockouts ¾" or 1". The standard Type 1 enclosure

is suitable for dry, indoor locations only in non-corrosive

environments.

9.0

For short circuit protection, heaters must be installed with

proper fast acting fuses or breakers as close as possible to the

ratings indicated on the nameplates, in compliance with the local

electrical codes.

4.0

To facilitate mounting, the heater has four ¼"-20 mounting

holes located at each top corner of the housing. Either chain

mounting (use eye bolts) or bolting to a non-combustible sliding

support (slotted holes) is adequate provided that the spacing

instructions as given in 3.0 are followed. Chain mounting is preferred

since rigidly mounted heaters are susceptible to warping.

38 cm

[15”]

60 cm

[24”]

30

cm

[12”

]

FIG. 1 – MOUNTING CLEARANCES

MI102 REV.7 Page 4 of 6

CCI Thermal Technologies Inc. 2721 Plymouth Drive, Oakville, ON L6H 5R5 Tel. (905) 829-4422 Fax (905) 829-4430

www.ccithermal.com

TM

RENEWAL PARTS LIST / PIÈCES DE RECHANGE

Parts common to all GX heaters/ Piéce communes à tous les appareil GX

PART NO.

Q/HTR.

DESCRIPTION

DÉCRIPTION

NO. DE PIÈCE

QTÉ./APPAREIL

Fan Guard / Motor Mount

Protecteur Éventail / Montage sur le Moteur

C11080-01

1

Louvres

Volet Directionnel

B12352-02

7

Control Door

Porte de Cabinet de Contrôle

B11082-01

1

Thermostat

Thermostat

B11031-02

1

Fan Delay Relay

Relais / Délais D'Éventail

B11043-02

1

Hi-Limit

Haute-Limite

B11035-03

1

Knob

Bouton du Thermostat

B11037-01

1

Specific parts based on heater catalog number / Pièce communes à tous les appareil GX

50VA TRANSFORMER

CAT

VOLTS/

ELEMENT

MOTOR

(240V Secondary)

(C) CONTACTOR (240V Coil)

FANBLADE

NO.

PHASE

ÉLÉMENT

MOTEUR

TRANSFORMATEUR 50 VA

(C) CONTACTEUR (Bobine 240V)

ÉVENTAIL

(Secondaire 240V)

(3 Required/Requis)

(1 Required/Requis)

GX152

208/3

KXF10008-25

B11085-01

NONE/AUCUN

C11055-02

GX153

240/1

KXF10008-26

Check Factory/Vèrifiez auprès de l'usine

NONE/AUCUN

Check Factory/Vérifiez auprères de l'usine

C11028-09

GX157

480/3

KXF10008-27

B11085-03

B11033-04

C11055-01

GX158

600/3

KXF10008-28

B11085-04

B11033-05

C11055-01

(3 Required/Requis)

(1 Required/Requis)

GX202

208/3

KXF10008-29

B11085-01

NONE/AUCUN

C11055-03

GX203

240/1

KXF10008-30

Check Factory/Vérifiez auprès de l'usine

NONE/AUCUN

Check Factory/Vérifiez auprès de l'usine

C11028-09

GX207

480/3

KXF10008-31

B11085-03

B11033-04

C11055-01

GX208

600/3

KXF10008-32

B11085-04

B11033-05

C11055-01

(3 Required/Requis)

(1 Required/Requis)

GX252

208/3

KXF10008-33

B11085-01

NONE/AUCUN

C11055-03

GX253

240/1

KXF10008-34

Check Factory/Vérifiez auprès de l'usine

NONE/AUCUN

Check Factory/Vérifiez auprès de l'usine

C11028-09

GX257

480/3

KXF10008-35

B11085-03

B11033-04

C11055-01

GX258

600/3

KXF10008-36

B11085 -04

B11033-05

C11055-01

(3 Required/Requis)

(1 Required/Requis)

GX307

480/3

KXF10008-31

B11085-03

B11033-04

C11055-01

C11028-10

GX308

600/3

KXF1000-38

B11085-04

B11033-05

C11055-01

(6 Required/Requis)

(2 Required/Requis)

GX407

480/3

KXF10008-31

B11085-03

B11033-04

C11055-01

C11028-10

GX408

600/3

KXF10008-32

B11085-04

B11033-05

C11055-01

(6 Required/Requis)

(2 Required/Requis)

GX507

480/3

KXF10008-35

B11085-03

B11033-04

C11055-01

C11028-10

GX508

600/3

KXF10008-36

B11085-04

B11033-05

C11055-01

NOTE: Above catalogue numbers are for basic units without controls. Units with built-in contactors and/or thermostats use identitical

components.

NOTE: Les numéros de catalogue représentent les appareils sans contrôles. Pours les appareils comprenenant des contacteurs et/ou des

thermostats intégrés, utilisez les composants identiques.

MI102 REV.7.01 Page 4 of 8

RENEWAL PARTS LIST / PIÈCES DE RECHANGE

Parts common to all GX heaters/ Piéce communes à tous les appareil GX

DESCRIPTION

DÉCRIPTION

PART NO.

NO. DE PIÈCE

Q/HTR.

QTÉ./APPAREIL

Fan Guard / Motor Mount

rotecteur Éventail / Montage

sur le Moteur

C11080-01

1

Louvres

Volet Directionnel

B12352-02

7

Control Door

Porte de Cabinet de Contrôle

B11082-01

1

Thermostat

Thermostat

B11031-02

1

Fan Delay Relay

Relais / Délais D’Éventail

B11043-02

1

Hi-Limit

Haute-Limite

B11035-03

1

Knob

Bouton du Thermostat

B11037-01

1

Specific parts based on heater catalog number / Pièce communes à tous les appareil GX

NOTE: Above catalogue numbers are for basic units without controls. Units with built-in contactors and/or thermostats use identitical omponents.

NOTE: Les numéros de catalogue représentent les appareils sans contrôles. Pours les appareils comprenenant des contacteurs et/ou des thermostats intégrés, utilisez les

composants identiques.

CAT NO.

VOLTS/

PHASE

ELEMENT

ÉLÉMENT

MOTOR

MOTEUR

50VA TRANSFORMER (240V

SECONDARY)

TRANSFORMATEUR 50 VA

(SECONDAIRE 240V)

(C) CONTACTOR (240V

COIL)

(C) CONTACTEUR (BO-

BINE 240V)

FANBLADE

ÉVENTAIL

GX152

GX153

GX157

GX158

208/3

240/1

480/3

600/3

(3 Required/Requis)

KXF10008-25

KXF10008-26

KXF10009-27

KXF10008-28

B11085-01

Check Factory/Vèrifiez auprès de

l’usine

B11085-03

B11085-04

NONE/AUCUN

NONE/AUCUN

B11033-04

B11033-05

(1 Required/Requis)

C11055-02

Check Factory/Vérifiez auprès

de l’usine

C11055-01

C11055-01

C11028-09

GX202

GX203

GX207

GX208

208/3

240/1

480/3

600/3

(3 Required/Requis)

KXF10008-29

KXF10008-30

KXF10009-31

KXF10008-32

B11085-01

Check Factory/Vèrifiez auprès de

l’usine

B11085-03

B11085-04

NONE/AUCUN

NONE/AUCUN

B11033-04

B11033-05

(1 Required/Requis)

C11055-02

Check Factory/Vérifiez auprès

de l’usine

C11055-01

C11055-01

C11028-09

GX252

GX253

GX257

GX258

208/3

240/1

480/3

600/3

(3 Required/Requis)

KXF10008-29

KXF10008-30

KXF10009-31

KXF10008-32

B11085-01

Check Factory/Vèrifiez auprès de

l’usine

B11085-03

B11085-04

NONE/AUCUN

NONE/AUCUN

B11033-04

B11033-05

(1 Required/Requis)

C11055-02

Check Factory/Vérifiez auprès

de l’usine

C11055-01

C11055-01

C11028-09

GX307

GX308

480/3

600/3

(3 Required/Requis)

KXF10008-31

KXF1000-38

B11085-03

B11085-04

B11033-04

B11033-05

(1 Required/Requis)

C11055-01

C11055-01

C11028-10

GX407

GX408

480/3

600/3

(6 Required/Requis)

KXF10008-31

KXF1000-38

B11085-03

B11085-04

B11033-04

B11033-05

(2 Required/Requis)

C11055-01

C11055-01

C11028-10

GX507

GX508

480/3

600/3

(6 Required/Requis)

KXF10008-35

KXF1000-36

B11085-03

B11085-04

B11033-04

B11033-05

(2 Required/Requis)

C11055-01

C11055-01

C11028-10

Advertising