Philips RI9946-47 - Manuel (Page 54)

46
1
4
7
2
5
8
3
6
9
Press the PUSH button to remove the
brew group.
Insert the used grounds drawer
and close the service door .
BreW GroUP CleaninG
Wash the brew group at least once a week. Before removing the group, remove the used grounds drawer as shown in fi g. 2 on page 44.
Wash the brew group with lukewarm water.
Lubricate the brew group after approximately 500 brewing cycles. The brew group lubricant may be purchased from an authorized service
center .
WARNING! Do not wash the brew group with detergents that may compromise its correct operation. Do not wash it in the
dishwasher.
Wash the brew group and the fi lter and
dry .
Insert the washed and dried brew group.
DO NOT PRESS THE “PUSH” BUTTON.
Make sure the brew group is in rest
position; the two references must match. Make sure the components are in the
correct position. The hook shown must
be in the correct position; to check its
position, fi rmly press the “PUSH” button.
The lever on the rear part of the group
must be in contact with the group
base .
Apply the lubricant evenly on both side
guides .
Lubricate the brew group guides using
the supplied lubricant .
CleaninG