Blodgett CNV14G - Manuel (Page 10)

Installation
6
Leg Attachment
LEG OPTIONS
Legs are available in 4" (101mm), 6" (152mm) āor
25" (ā635mm) ālengths āāor āālow profile casters.
D The 4" (101mm) legs may be used when mountĆ
ing on a counter.
D The 6" (152.4mm) legs are used on the lower
section of a double stacked appliance.
D The ā25" (635mm) legs are used for a single apĆ
pliance located on the floor.
NOTE: For safety reasons, casters must not be
used with the 25" (635mm) legs.
4" (101mm) Leg
6" (152,4mm) Adjustable Leg
Low Profile Casters
25" (635mm) Adjustable Leg
Figure 2
ATTACHMENT
1. Align the threaded stud on one of the front
legs to the bolt āholeā locatedāāā ināā ātheāā bottom ācorĆ
ner of the appliance. Turn the leg clockwise
and tighten to the nearest full turn.
2. Align the leg plate holes with the bolt holes.
Secure with the two 1/2" bolts provided.
3. Repeat the above steps with the other front
leg. If low profile casters are used, install them
with the locking casters in the front of the oven.
The rear casters do not lock. Ensure that the
locks are set on the front casters.
4. Tip the oven up on the newly installed front
legs. If ācastersā are āused, checkā thatā the locksā
areā setā on ātheā front casters. āRepeat āthe above
steps for the rear legs.
5. Except for appliances with casters, level the
oven by screwing the adjustable feet in or out
as necessary.
Figure 3