Britax Child Seat - Manuel (Page 19)

34 35
Harness Buckle Removal
Fully recline the child seat. 1
Locate the metal buckle strap retainer 2
on the bottom of the child seat.
Pull the retainer away from the child 3
seat to loosen.
Turn the retainer so the short side will 4
go through the slot in the child seat shell
(Fig. A).
Push the retainer through the slots in the shell and cover to the 5
top of the child seat.
Re-threading the Harness Buckle
Locate the slot in the cover and shell for the harness buckle. 1
Turn the metal buckle strap retainer so the short side will go 2
through the slot in the cover and the child seat shell (Fig A).
Push the retainer through the slots in the shell and cover, to the 3
bottom of the child seat.
Pull the harness buckle away from the child seat until tight and 4
verify the harness buckle strap is not twisted and the release
button is facing outward.
Care and Maintenance Care and Maintenance
A
Refitting the Cover
To refit the cover, reverse the previous directions. Make sure the
harness straps are properly threaded through the chest clips and
the harness is not twisted.
Cleaning the Cover
HAND WASH using cold water and mild soap. •
LINE or LIE-FLAT DRY to prevent the cover from shrinking. •
DO NOT • bleach, machine wash, machine dry or iron.
Cleaning the Shell
SPONGE CLEAN using warm water and mild soap. •
TOWEL DRY •
DO NOT • use solvents, abrasive cleaners or disassemble the
harness.
Cleaning the Harness
SPONGE CLEAN using warm water and mild soap. •
TOWEL DRY •
DO NOT • bleach, machine wash, machine dry or disassemble
the harness.