Britax Child Seat - Manuel (Page 16)

28 29
Switching the Lower Connector System (LCS)
The LCS strap may need to be switched to the proper
belt path in rear-facing (Fig. A) versus forward-facing
(Fig. B) installations. If a proper connection of the LCS
connectors to the LUAS anchors cannot be achieved,
complete the following procedure to switch the
connectors.
Lift the front of the child seat cover to access the 1
LCS connectors.
Pass the LCS connector strap through the belt 2
path on the child’s right side (Fig. C).
Pass one LCS connector through the appropriate 3
belt path ensuring that the larger part of the
connector is on top for the installation procedure
you wish to use (Fig D).
Verify that the harness is not twisted. •
IMPORTANT: When installing this child seat in rear-
facing mode, the LCS strap must rest behind the
child seat buckle strap.
NOTE: To ensure LCS connector is properly aligned
with vehicle’s LUAS anchor, the connector’s red
release button should face away from vehicle seat
back, and the larger of the two connector sections is
on top (Fig. D).
Replace the cover and continue with the installation 4
procedure.
Storing the LCS Connectors
When the LCS connectors are not in use, lift the
child seat cover to access LCS storage slots (Fig. E).
Fold each end of the LCS strap and slide each LCS
connector into the adjacent slots.
NOTE : Child seats are shipped from Britax with LCS
connectors in the storage slots.
Recline Adjustment
Pull the recline handle then slide the child seat shell into
the desired position. (Fig. F) Release the recline handle
and verify the child seat has locked into position.
NOTE : It will be necessary to loosen the tether,
vehicle seat belt, and/or LCS strap before adjusting
the recline position. The tether, vehicle seat belt,
and/or LCS strap must be properly re-tightened after
adjusting the recline position.
Chest Clip
Fastening the Chest Clip
Fasten the chest clip by pushing the two halves
together until a positive click is heard.
Releasing the Chest Clip
Squeeze the middle tab together. 1
Pull apart the two pieces (Fig. G). 2
Adjusting the Chest Clip
Slide chest clip up or down on harness so it is
positioned at the middle of the child’s chest, level with
the child’s armpits (Fig. H).
Child Seat Functions
d
Top
Release
Button
Child Seat Functions
e
f
G c
h
A
Rear-facing
A
Forward-facing
WARNING!
This child seat must be in the recline position when •
installed rear-facing.
Child seat must be in. full upright position when •
installed forward-facing .