AEG F77012M0P - Manuel (Page 35)

4
3
2
1
3. Remove the worktop of the
appliance.
4. Loosen or tighten the adjust-
able feet for a correct level of
the appliance.
With a correct level the appli-
ance door closes and seals
correctly.
5. Install the appliance under
the kitchen counter.
11.2 Water drain connection
max.
4000 mm
min. 400 mm
max. 850 mm
Connect the water drain hose to:
• The sink spigot. Attach the water drain
hose under the kitchen counter. This
prevents that waste water from the
sink goes back to the appliance.
• A stand pipe with vent-hole. The inter-
nal diameter must be minimum 40
mm.
Remove the sink plug when the appli-
ance drains. This prevents water to go
back to the appliance.
An extension hose for the water drain
hose must be shorter than 2 m and with
the same diameter as the water drain
hose.
A
If you connect the water drain hose to a
trap spigot under the sink, remove the
plastic membrane (A). A not complete
removal of the membrane causes a
blockage in the spigot and problems
with drain.
The appliance has a non-return valve
that prevents dirty water to go back to
the appliance. If there is a non-return
valve in the sink spigot, remove it to pre-
vent the appliance to drain incorrectly.
ENGLISH
35