Amana W10261420A - Manuel (Page 12)

12
Terminal box wire:
white
black
ground connector
Power supply wire:
white
black
ground wire
Wiring configuration
If needed, see website for animated representation of this step.
Visit www.amana.com under FAQ tab.
Tighten strain relief screws to secure cord.
Power Cord—Secure cord
on conduit connector 4
Place wires inside terminal box. Insert tabs on
left side of cover. Make sure wires are tucked inside box. Close
cover ensuring wires are not pinched. Use
¹⁄₄” nut driver and
previously removed screw to secure cover.
NOTE: Do not plug into outlet until instructed.
Power Cord—Reinstall
terminal box cover 5
Measure height of cabinet opening from underside of
countertop to floor where dishwasher will be installed (you will
need to measure the lowest point on the underside of the
countertop and the highest point on the floor). Refer to
“Dishwasher Height Adjustment Chart” for wheel position and
the number of turns needed.
Measure cabinet opening 1
Determine Cabinet Opening
Cabinet
opening height
34" (86.4 cm) 1 10
34 ¹⁄₄" (87 cm) 2 5
34 ¹⁄₂" (87.6 cm) 3 0
33 ⁷⁄₈" (86.0 cm) Removed All the way up
Wheel
position
Number of turns
on front leg
Dishwasher Height Adjustment Chart
NOTE: If the minimum cabinet opening height is less than
34”(86.4 cm), the rear wheels can be removed for additional
clearance. This will allow the dishwasher to fit into a 33
⁷⁄₈”
(86 cm) high cabinet opening, but the dishwasher will be more
difficult to move. (Measurements are approximate. Wheels and
legs are preset at the factory for 34
¹⁄₂” [87.6” cm].)
NOTE: Do not pre-twist stranded wire. Twist on wire connector.
Gently tug on wires to be sure both are secured.
Connect wires black to black and white to white, using UL
Listed/CSA Approved twist-on wire connectors (not included).
Power Cord—Connect
remaining wires 3