Amana W10261420A - Manuel (Page 10)

10
Apply Teflon ® tape
or pipe joint compound
4
Coarse threads Coarse threads
Apply Teflon tape or pipe joint compound to 90˚ elbow fitting
(not provided). Wrap tape around coarse threads 2 to 4 times to
avoid leaks.
Connect 90° elbow fitting to
water inlet valve 5
Connect 90° elbow fitting to water inlet valve. Using a wrench,
tighten elbow until snug, and be sure that it faces to the rear.
Excessive Weight Hazard
Use two or more people to move and install
dishwasher.
Failure to do so can result in back or other injury.
WARNING
WARNING
Tip Over Hazard
Do not use dishwasher until completely installed.
Do not push down on open door.
Doing so can result in serious injury or cuts.
Prepare Dishwasher
Put dishwasher on its back 2
Helpful Tip: Place cardboard under dishwasher until installed in
cabinet opening to avoid damaging floor covering. Do not use door
panel as a work table without first covering with a towel to avoid
scratching the door panel.
Using 2 or more people, grasp sides of dishwasher door frame and
place dishwasher on its back.
Remove panels 3
Using a
¹⁄₄” hex head socket, nut driver or Phillips screwdriver,
remove 2 screws attaching access panel and lower panel to
dishwasher.
NOTE: Do not remove tech sheet from access panel.
Tabs
Completed
Install
Attach insulation 1
Using the precut slots in the insulation, fasten the insulation over the
molded hooks on the tub. Be sure to fasten the insulation down on
both sides of the tub.