Trademark Tools AIR COMPRESSOR 2.5HP/20 GALLON - Manuel (Page 6)

OPERATION
DAILY START UP
1. Turn the ON/OFF switch to the OFF position (see A).
2. Close the tank drain valve (see D). Turn clockwise.
3. Plug in the power cord.
WARNING：
High temperatures are generated by the electric motor
and the pump. To prevent burns or other injuries, DO
NOT touch the compressor while it is running. Allow it to
cool before handing or servicing. Keep children away
from the compressor at all times.
4. Turn the ON/OFF switch to the ON position (see C)
WARNING：
When adjusting from a higher to a lower pressure, turn
the knob counterclockwise past the desired setting, then
turn clockwise to reach the desired pressure. Do not
exceed operating pressure of the tool or accessory being
used.
5. If a pressure regulator is present on your compressor,
adjust it to the working pressure of the tool.
SHUTDOWN
1. Turn the ON/OFF switch to the OFF position.
2. Unplug the power cord.
3. Reduce pressure in the tank through the outlet hose. You
can also pull the relief valve ring (See E) and keep it open
to relieve pressure in the tank.
CAUTION
Escaping air and moisture can propel debris that may
cause eye injury. Wear safety goggles when opening drain
valve.
4. Tip the compressor (if necessary for your model) so the
tank drain valve is at the bottom of the tank. Then open the
tank drain valve (see B) to allow moisture to drain from the
tank.
C---ON
A---OFF
OPERATION
CLOSE
OPEN
D
-6-
E
B