Napoleon Fireplaces GDS60 - Manuel (Page 30)

W415-0788 / F / 10.21.13
30
EN
5.3 APPLIANCE VENT CONNECTION - MODEL GDS60
A. Attach the adjustable pipe to the last section of rigid pipe.
Secure with screws and seal.
B. Install the inner fl ex pipe to the appliance. Secure with 3
screws and fl at washers. Seal the joint and screw holes using
the high temperature sealant W573-0007 (not supplied).
C. Run a bead of high temperature sealant (not supplied) around
the inside of the air intake collar. Pull the adjustable pipe a
minimum 2” (50.8mm) into the air intake collar.
NOTE: Ensure that the sealant is not visible on the exterior pipes once installation is completed. An
optional decorative black band is available for this use. In the event that the venting must be disassembled,
care must be taken to reseal the venting.
28.3A
2” (50.8mm)
OVERLAP
HIGH TEMPERATURE
SEALANT
#8 X 1/2”
SELF
DRILLING
SCREWS