Napoleon Fireplaces Outdoor Torch - GSST8 - Manuel (Page 25)

25
W415-0689 / C / 06.13.12
SYMPTOM PROBLEM TEST SOLUTION
Burner will not light,
ignitor sparks. No gas at the burner. - Check that the manual valve is turned on.
- Replace the valve.
Out of propane gas. - Fill the tank.
Ignitor will not spark. No spark at ignitor. - Check the power source. (ie. fuse, circuit breaker)
- Check that the wire is connected to both the ignitor
and the control module.
- Check that the spark is not jumping to ignitor cover.
- Replace the wire if the wire insulation is broken or
frayed.
- Replace the electrode if the ceramic insulator is
cracked or broken.
Spark gap is incorrect. - Spark gap should be 0.125” (1/8” approx.) from the
electrode tip to the sensor tip.
Remote wall switch
is in “OFF” position;
burner comes on. Wall switch is mounted
upside down. - Reverse.
Remote wall switch is
grounding. - Replace.
Remote wall switch
wire is grounding. - Check for ground (short); repair ground or replace
wire.
Faulty wire. - Replace.
CERAMIC
BODY
ELECTRODE
HIGH
VOLTAGE
IGNITION
CABLE
1/8”
GAP
SENSOR
42.22_2