Napoleon Fireplaces EF39HD - Manuel (Page 11)

11
W415-0752 / D / 02.03.12
5.0 OPERATING INSTRUCTIONS
Once the appliance has been plugged into a grounded electrical outlet, it is ready to operate.
NOTE: Ensure the house circuit breakers for the power supply are turned on. In the event of a power
failure, when the main power switch is in the "I" ON position and the hand held remote control is in the
OFF position, the fl ame generation lights will come on at the high setting.
The Main Power Switch is located on the bottom of the appliance as il-
lustrated.
The "|" indicates ON and "O" indicates OFF. Push the switch to "|" to turn
on the appliance and the fl ame effect.
5.1 MAIN POWER SWITCH
Power (on/off)
BOTTOM VIEW
5.2 OPERATING BY REMOTE CONTROL
NOTE: Make certain the batteries are installed correctly and are new.
A. Plug in your electric appliance.
B. Make certain the appliance’s Main Power Switch is at the ON
position! The remote control will NOT work if the Main Power
Switch is at the OFF position.
C. When operating the remote control, it must be directed towards
the front center of the appliance.
D. The button at the top left of the remote can be used to power
up or down the appliance (the main power switch on the appliance
must be in the ON position for the remote to operate). Pressing
this button activates the power to the appliance.
E. To activate the heater, press the button. Press and release the
button to cycle through LO, MED, HI and OFF.
F. To adjust the fl ame height and ember bed brightness, press the
“ +” or “ -” buttons. To increase the fl ame height and ember
bed brightness, press the “ +” button, to decrease the fl ame
height and ember bed brightness, press the “ -” button. There
are seven levels of fl ame effects.
G. To turn off the appliance, press the button once. NOTE: This
remote control must remain within 8 meters or 26 feet of the
appliance to be effective and this range may be reduced as
the battery power is depleted.
Infrared Ray Exit
Indicator
Light
-
+