Napoleon Fireplaces B35NT - Manuel (Page 39)

39
W415-1232 / B / 05.15.14
EN
6.7 WIRING DIAGRAM
A wall switch or remote control must be installed in a convenient location to operate the main burner. A 20’ (6.1m)
length of 18 gauge wire is connected to the gas valve wire harness for this wall switch, however, if a greater length
is required route 2-strand (solid core) wire complete with two 1/4” (6.4mm) insulated male quick connects through
the electrical hole located at the bottom left side of the appliance and connect to the wire harness as shown.
B ATTERY H OLDER
P ILOT
A
SSEMBLY
I
GNITION
M ODULE
P
ILOT
G AS L INE
White
(S)
[through
Gas line
conduit]
Red
Black
N OTE : W IRE TAGS
ARE BRACKETED
AC A DAPTOR
Black (3 Volt)
PTIONAL O
PILOT
IN OUT
ADJ
HI
LO
VENT
Black Red Brown
Black
Black
W IRE
H ARNESS
Orange
Grounded to Sheet Metal
Red
Black
M
AIN
B
URNER
S
WITCH
G AS
V
ALVE
RACKET B
DRAFT
NOTE: The battery holder was supplied with your appliance but not connected. In an event of a power
failure, install two 'D' batteries in the holder and attach to wire harness as illustrated above.