Sony STR-LSA1 - Manuel (Page 9)

9 GB
Basic Operation
z
To verify which component is currently selected
Press DISPLAY. If the selected component is the CDP-LSA1 or
MDS-LSA1, “N N n n” appears for a few seconds in the
display of the component.
This function is especially useful for verifying the selected
component when more than one component of the same type
(e.g., two CD players) are connected to the receiver. Note that
this function works with Sony components only. For more
details, see page 24.
z
You can monitor the CD sound while recording from a CD to
an MD (when using the CDP-LSA1 and MDS-LSA1 only)
Switch the program source to the MD deck as you are recording.
However, the sound can’t be monitored during High-speed CD
Synchro-recording.
z
The LINC between the receiver and the program source is
automatically established
The receiver automatically establishes a LINC with a component
when you select it as the program source. The LINC is
automatically canceled when you turn off the receiver or when
you select a non-i.LINK component as the program source. For
details on “Establishing a LINC,” see page 27.
If you don’t obtain normal sound output after performing
the procedure in page 8, look for the reason in the
checklist below and take the appropriate measures to
correct the problem.
There is no sound no matter which component is
selected.
, Check that both the receiver and all components
are turned on.
, Check that the volume level isn’t turned down to –
∞
dB.
, Check that all speaker cables are connected
correctly.
, Press the MUTING button on the remote to turn
off the MUTING indicator on the receiver.
There’s no sound from a specific component.
, Check that the cable(s) used for the connection is
(are) fully inserted into the connectors on both the
receiver and the component.
The program source can’t be selected or changed.
, The selection of a program source is momentarily
disabled after the component hookup has been
changed (“NEW CONNECT” appears in the
display at this time). “FUNC. Locked” appears in
the display of the receiver if you try to select a
program source at this time.
, The program source can’t be changed while a
component is establishing a LINC with the
receiver; e.g., when an MD deck is establishing a
LINC with the receiver in order to record a radio
program on the MD. “FUNC. Locked” appears in
the display of the receiver if you try to select a
program source at this time.
There are other circumstances under which the
program source cannot be selected. In these cases,
note the contents of the error message that appears
in the display and see “Display Messages” on page
31.
No sound is heard from one of the speakers.
, Connect a pair of headphones to the PHONES
connector to verify that sound is output from the
headphones.
If only one channel is output from the headphones,
the component may not be connected to the
receiver correctly. Check that all the cables are
fully inserted into the connectors on both the
receiver and the component.
If both channels are output from the headphones,
the speaker may not be connected to the receiver
correctly. Check the connection of the speaker
which is not outputting any sound.
The left and right speaker output is unbalanced.
, Press the JOG MENU button repeatedly until
“Sound Menu” appears in the display. Then rotate
the jog dial until “SP. Balance” appears in the
display, and then press the ENTER button. Rotate
the jog dial to adjust the speaker balance.
If you encounter a problem that is not included above, see
“Troubleshooting” on page 28.
z
When a message appears in the display
See page 31.