Sony STR-LSA1 - Manuel (Page 25)

25 GB
Other Operations
Other Settings Using the Setup Menu
Verifying which component is currently
selected (Ping function)
When the Ping function is turned on, you can verify
which of the components is currently selected by pressing
the DISPLAY button on the receiver. An indication
momentarily appears in the display of the currently
selected component. The indication varies depending on
the component. For example, if the selected component is
either the CDP-LSA1 or the MDS-LSA1,
“N N n n” appears in the display of the
component. Note that this function works on Sony
i.LINK MD deck and CD player only.
1
Press JOG MENU repeatedly until “Setup Menu”
appears in the display.
2 Rotate the jog dial until “Ping” appears in the
display, and then press ENTER.
3
Rotate the jog dial until “On” appears in the
display, and then press ENTER.
To turn off the Ping function
Do the procedure above, selecting “Off” in step 3.
Improving the quality of the audio signal
(H.A.T.S. function)
When the H.A.T.S. function is turned on, digital audio
signals are momentarily stored in a buffer prior to output.
This reduces the jitter that sometimes occurs during
digital transmission. When this function is turned on, the
H.A.T.S. indicator on the front panel lights up whenever
the digital audio signal is input to the receiver.
1
Press JOG MENU repeatedly until “Setup Menu”
appears in the display.
2 Rotate the jog dial until “H.A.T.S.” appears in the
display, and then press ENTER.
3
Rotate the jog dial until “On” appears in the
display, and then press ENTER.
To turn off the H.A.T.S. function
Do the procedure above, selecting “Off” in step 3.
Notes
• Due to the operating principle of the H.A.T.S. function, a slight
time lag is introduced between the initiation of an operation
(e.g., pressing the play button, stop button, or pause button)
and the actual audio output.
• The H.A.T.S. function is effective only for the components
supporting this function.
• On this receiver, the H.A.T.S. function works only with digital
audio signals with a sampling frequency of 44.1 kHz.
• The H.A.T.S. function does not work when the program source
component selected by the receiver is also selected by another
component (e.g., another receiver or the MD deck). This is
because the receiver controls the transmission rate of the digital
audio signals output from the program source component, and
for proper signal transmission, there must be only one
component which receives audio signal from a source
component within the i.LINK configuration.
• The H.A.T.S. function doesn’t work under the following
conditions:
— When the MD is recording from the CD player, and the CD
player or the MD deck is selected as the program source.
— When the sampling frequency of the digital signal is not 44.1
kHz.
Clearing the receiver’s memory
The procedure below clears all the menu settings you
made from the receiver’s memory and restores the factory
settings.
1
Press JOG MENU repeatedly until “Setup Menu”
appears in the display.
2 Rotate the jog dial until “All Clear” appears in the
display, and then press ENTER.
3
Rotate the jog dial until “Yes” appears in the
display, and then press ENTER.
“Make Sure ?” appears in the display.
4
Rotate the jog dial until “Yes” appears in the
display, and then press ENTER.