Sony SMP-U10 - Manuel (Page 13)

13 US
H
ook
up
s and
Se
tti
n
gs
To control other TVs with the remote
You can control the volume, input source, and
power switch of non-Sony TVs as well.
If your TV is listed in the table below, set the
appropriate manufacturer’s code.
b
When you replace the batteries of the remote, the
code number may be reset to the default setting. Set
the appropriate code number again.
1
While holding down TV [/1, press the
number buttons to select your TV’s
manufacturer’s code.
2
Release TV [/1.
Code numbers of controllable TVs
If more than one code number is listed, try
entering them one at a time until you find the
one that works with your TV.
Step 5: Quick Setup
Follow the steps below to make the minimum
number of basic adjustments for using the
player.
To skip an adjustment, press >. To return
to the previous adjustment, press ..
1
Turn on the TV, then press [/1.
2
Switch the input selector on your
TV so that the signal from the
player appears on your TV screen.
“Press [ENTER] to run QUICK SETUP”
appears at the bottom of the screen. If this
message does not appear, select
“QUICK” under “SETUP” in the Control
Menu to run Quick Setup (page 19).
3
Press ENTER without connecting a
USB device.
The Language Setup Display appears.
4
Press X/x to select a language.
The player displays the menu and
subtitles in the selected language.
5
Press ENTER.
The Screen Setup Display appears.
6
Press X/x to select the setting that
matches your TV type.
Select “16:9” or “4:3 LETTER BOX”
(page 22).
7
Press ENTER.
The Setup Display for selecting the type
of jack used to connect your audio
component appears.
Manufacturer Code number
Sony 01 (default)
Hitachi 24
LG/Goldstar 76
Panasonic 17, 49
Philips 06, 08, 72
RCA 77
Samsung 71
Sharp 29
Toshiba 38
,continued