Sony SCD-XA5400ES - Manuel (Page 29)

Ad
diti
onal
Inf
o
rma
tion
29 GB
No video is output from the HDMI OUT jack.
• The HDMI OUT jack of the player outputs blue
signal in the NTSC system only. It does not output
any other video signal.
No sound is heard, and “Unmatched Sink”
appears on the display.
• The component connected to the HDMI OUT jack
cannot receive the output signal of Super Audio
CDs. Connect the component to the ANALOG
OUT jacks.
The TIME/TEXT, MULTI/2CH, SA-CD/CD
buttons on the player do not light up.
• The TIME/TEXT, MULTI/2CH, SA-CD/CD
buttons do not light up. The states of these button
settings are shown on the display window.
No sound is heard, and “Press Stop” appears
on the display.
• When the player is in the HDMI ON mode, if you
connect the player and the amplifier while you are
playing back a Super Audio CD, sound may not be
output. Stop playback once, then start playback
again.
No sound is heard, and “Connected DVI”
appears on the display.
• If a DVI connection is made to the HDMI OUT
jack, no sound will be output. Connect the player
to an HDMI component that comply with audio
input.
After you have attempted the
prescribed corrective actions
If the player still does not operate properly, or if
other problems not described above occur, turn
off the player, unplug it from the power outlet
for a few minutes, then reinsert the plug into the
power outlet.
Note
When you turn on the power of the player, you may
hear a rattling sound from inside the player. This is
because the player is determining the type of disc or
making adjustments, and does not indicate a
malfunction of the player.
When a Super Audio CD is played
Playing frequency range 2 Hz to 100 kHz
Frequency response 2 Hz to 50 kHz (–3 dB)
Dynamic range 110 dB or more
Total harmonic distortion rate
0.0012 % or less
Wow and flutter Value of measurable limit
(±0.001 % W. PEAK) or
less
When a CD is played
Frequency response 2 Hz to 20 kHz (±0.5 dB)
Dynamic range 100 dB or more
Total harmonic distortion rate
0.0017 % or less
Wow and flutter Value of measurable limit
(±0.001 % W. PEAK) or
less
Output jacks
* Outputs only the audio signals of the CD
Specifications
Jack type Output
level Load
impedance
ANALOG
OUT UN-
BALANCED Phono
jacks 2 Vrms
(at 50
kilohms) Over 10
kilohms
ANALOG
OUT
BALANCED XLR 2 Vrms
(at 50
kilohms) Over 600
ohms
HDMI HDMI
DIGITAL
OUT (CD)
OPTICAL* Square
optical
output
connector –18 dBm (Light
emitting
wave
length: 660
nm)
DIGITAL
OUT (CD)
COAXIAL* Coaxial
output
connector 0.5 Vp-p 75 ohms
PHONES Stereo
phone jack 5 mW 32 ohms
continued