Sony SCD-XA5400ES - Manuel (Page 14)

14 GB
Notes
• It is recommended to use an HDMI cable of category
2 to connect the player.
• The HDMI OUT jack of the player outputs only the
blue signal as video. It does not output any other
video signals.
• Depending on the HDMI performance of the
connected component (the format, sampling
frequency, resolution, receivability of copyright
protection signal from Super Audio CDs, etc.), no
audio signal may be output from the HDMI OUT
jack of the player. In this case, “HDMI” will not light
up on the display.
Connecting a digital
component with the coaxial
digital input jack
Use a coaxial digital cable for this connection.
Coaxial digital cable (not supplied)
Note
Only the audio signals of conventional CDs can be
output from the DIGITAL OUT (CD) COAXIAL jack.
Those of Super Audio CDs cannot be output through
the jack.
Connecting a digital
component with the optical
digital input jack
Use an optical digital cable for this connection.
When connecting the optical digital cable to the
DIGITAL OUT (CD) OPTICAL jack, push the
cable plug in until it clicks into place.
Be careful not to bend or twist the optical cable.
Optical digital cable (not supplied)
Note
Only the audio signals of conventional CDs can be
output from the DIGITAL OUT (CD) OPTICAL jack.
Those of Super Audio CDs cannot be output through
the jack.
Connecting the AC power
cord
Connect the supplied AC power cord to the AC
IN terminal on the player and to the AC outlet
(mains).
A several space is left between the plug and the
rear panel even when the AC power cord (mains
To CD coaxial digital input jack on an
MD deck, etc.
To CD optical digital input jack on an
MD deck, etc.