Electrolux EDC78550W - Manuel (Page 13)

2. Open door in plinth. To do this, press
the release button on the bottom of the
door aperture and open the door in the
plinth to the left.
3. Clean fluff from the inside of the door
and the heat exchanger front chamber.
Wipe the door seal with a damp cloth.
4. Turn both lock washers inwards.
5. Use the handle to pull the heat exchang-
er out of the base and carry it horizontal-
ly to prevent any remaining water from
spilling.
6. To empty the heat exchanger, hold verti-
cally over a washing-up bowl.
Caution! Do not use sharp objects to
clean. The heat exchanger could
develop leaks.
7. Clean heat exchanger.
It is best to use a brush or to rinse thor-
oughly with a hand-held shower.
8. Replace heat exchanger and lock into
place (turn both lock washers outwards
until they snap into place).
9. Close door in plinth.
The appliance will not operate if the
HEAT EXCHANGER indicator is still lit.
Caution! Never operate the dryer
without the heat exchanger.
Cleaning the drum
Caution! Do not use abrasives or steel
wool to clean the drum.
Lime in the water or cleaning agents
may form a barely visible lining on the in-
side of the drum. The degree to which
the laundry has been dried is then no
longer detected reliably. The laundry is
damper than expected when removed
from the appliance.
Use a standard domestic cleaner (e.g. vine-
gar-based cleaner) to wipe down the inside
of the drum and drum ribs.
Clean control panel and housing
Caution! Do not use furniture cleaners
or aggressive cleaning agents to clean
the machine.
Use a damp cloth to wipe down the control
panel and housing.
electrolux 13