Electrolux EDC78550W - Manuel (Page 12)

can be positioned with the tooth facing
to the left or to the right). After cleaning
do not forget to put it back.
4. Remove fluff from lint filter, preferably us-
ing a damp hand for this purpose.
5. Replace the filter.
Clean the door seal
Wipe the door seal with a damp cloth imme-
diately after the drying cycle has finished.
Emptying the water reservoir
Empty the water reservoir after every drying
cycle.
If the water reservoir is full, an active pro-
gramme will break off automatically and the
warning lamp
lights. In order to continue
the programme, the water reservoir must
first be emptied.
Warning! The condensed water is not
suitable for drinking or for preparing
foodstuffs.
1. Take out water reservoir completely.
2. Pour condensed water out into a basin
or similar receptacle.
3. Refit water reservoir.
If the programme has been interrupted
as a result of the water reservoir being
full: Press the START/PAUZE (Start/
Pause) button to continue the drying cy-
cle.
The water reservoir has a volume of ap-
prox. 4,5 litres. This is sufficient for
around 8 kg of laundry which has previ-
ously been spun at 1000 revolutions /
minute.
The condensed water can be used as
distilled water, e.g. for steam ironing.
However it must first be filtered (e.g.
with a coffee filter) to remove any resi-
due and small pieces of fluff.
Cleaning heat exchanger
If the
HEAT EXCHANGER is displayed,
the heat exchanger needs to be cleaned.
Caution! Operating when the heat
exchanger is blocked with fluff can
damage the dryer. This also increases
energy consumption.
1. Open door.
12 electrolux