MAX AKHL1250E - Manuel (Page 9)

9
28. DO NOT STOP COMPRESSOR BY PULL-
ING OUT THE PLUG
Use the " ON/OFF " switch.
29. WHENEVER USING THE HIGH PRESSURE
SIDE OF THE MAX POWERLITE COMPRES-
SOR, THE GENUINE PARTS FOR THE MAX
POWERLITE TOOLS, POWERLITE HOSE
AND COMPRESSOR MUST BE USED.
30. NEVER USE A TRANSFORMER FOR THE
POWER SUPPLY OF THIS COMPRESSOR.
USING A TRANSFORMER TO INCREASE THE
VOLTAGE WILL CAUSE A FAILURE OR
BURNOUT. (IF A TRANSFORMER IS USED,
OPERATION OF THE MACHINE WILL STOP.)
31. NEVER CONNECT THE COMPRESSOR
TO AN ENGINE GENERATOR OR DI-
RECT-CURRENT POWER SUPPLY
The compressor will break or be damaged
from burning.
32. THIS COMPRESSOR IS FOR INDOOR
USE. DO NOT INSTALL THE COMPRES-
SOR IN ANY PLACE EXPOSED TO RAIN
OR SPLASHED WATER, HIGH-HUMIDITY
PLACE OR HIGH-TEMPERATURE PLACE
If used in the wet condition, it could produce
an electric shock or be short-circuited, result-
ing in ignition. Use it under the environmen-
tal conditions provided by its specifications.
33. DO NOT OPERATE THE TOOL NEAR A
FLAMMABLE SUBSTANCE
Never operate the tool near a flammable
substance (e.g., thinner, gasoline, etc.). Vol-
atile fumes from these substances could be
drawn into the compressor and compressed
together with the air and this could result in
an explosion.
34. NEVER USE THE TOOL IN AN EXPLO-
SIVE ATMOSPHERE
Sparks from the tool may ignite atmospheric
gases, dust or other combustible materials.
35. BE SURE TO EARTH THE COMPRESSOR
Earth the compressor to prevent a worker
from getting an electric shock. It comes with
a 3-pole cord and a 3-pole earthing plug so
that it can be connected to an appropriate
earthing plug socket.
A green-and-yellow striped wire is an earth-
ing conductor. Never connect it to other
charged terminals.
36. WHEN CARRYING THE COMPRESSOR,
HOLD IT CORRECTLY.
37. TAKE CARE TO TRANSPORT THE COM-
PRESSOR CORRECTLY, DO NOT OVER-
TURN IT OR LIFT IT WITH HOOKS OR
ROPES.
38. WHEN DISPOSING THE MACHINE OR ITS
PARTS, FOLLOW THE RELEVANT NA-
TIONAL RULES.
39. DO NOT PUT FINGERS IN THE BLEEDER
OR CLEARANCES IN THE HOUSING.
This can result in injury, electric shock or
burns.
40. DO NOT USE ANY ADAPTER PLUGS
WITH THE COMPRESSOR
The compressor is factory-equipped with a
specific electric cord and plug for connection
to a proper electric power source. Never
modify the plug in any way. Donot use any
adapter plugs with the compressor.