Camp Chef FP29TG - Manuel (Page 2)

Improper installation,
adjustment, alteration, service
or maintenance can cause
injury or property damage.
Read the installation,
operating and maintenance
instructions thoroughly
before installing or servicing
this equipment.
WARNING
If the information in this
manual is not followed
exactly, a fire or explosion
may result causing property
damage, personal injury or
loss of life.
WHAT TO DO IF YOU SMELL GAS.
• Do not try to light any appliance.
• Do not touch any electrical switch; do not use
any phone in your building.
• Immediately call your gas supplier from
a neighbor’s phone. Follow the gas
supplier’s instructions.
• If you cannot reach your gas supplier, call the
fire department. Installation and service must
be performed by a qualified installer, service
agency or gas supplier.
FOR OUTDOOR USE ONLY!
Do not operate the fire pit indoors, in a
garage, or in any other enclosed area or under
overhead construction. Do not operate fire pit
near flammable materials such as decks, fences,
porches or carports. A minimum clearance range
of 72” inches is recommended. Do not use the
fire pit near gasoline or other combustible
liquids or where combustible vapors may be
present.
Children and adults should be alerted to the
hazards of high surface temperatures and should
stay away to avoid burns or clothing ignition.
Young children should be carefully supervised
when they are in the area of the appliance.
Clothing or other flammable materials should
not be hung from the appliance, or placed
on or near the appliance. Any guard or other
protective device removed for servicing the
appliance must be replaced prior to operating
the appliance.
Installation and repair should be done by a
qualified service person The appliance should
be inspected before use and at least annually
by a qualified service person. More frequent
cleaning may be required as necessary. It is
imperative that control compartment, burners
and circulating air passageways of the appliance
be kept clean.
Use caution when assembling and operating fire
pit to avoid cuts and scrapes from rough or sharp
edges.
DO NOT move the fire pit while it is in use. Allow
the fire pit to cool completely before moving or
storing.
When in use, the fire pit must be on a level,
stable surface in an area clear of combustible
material. An asphalt surface (blacktop) may not
be acceptable for this purpose. Do not operate
fire pit on flammable material such as carpet or a
wood deck. Store the fire pit in a dry, protected
location.
This fire pit is not intended for and should never
be used as a heater.
DO NOT leave fire pit unattended while in use.
Operate the fire pit with close supervision.
DO NOT operate around children or animals.
DO NOT bump or tip fire pit. If fire pit becomes
extremely hot, allow fire pit to cool completely
before handling. If you must handle the fire pit
while it is hot, always wear protective oven mitts
or heat resistant gloves when handling the fire
pit or its components.
DO NOT obstruct flow of combustion air and/or
ventilation air for fire pit.
DO NOT wear loose clothing while operating the
fire pit. Tie back long hair while operating the
fire pit. ALWAYS wear fully covering shoes while
operating the fire pit.
Allow fire pit and its components to cool
completely before conducting any routine
cleaning or maintenance. Do not move the fire
pit when in use. Allow the fire pit to cool before
moving or storing.
DO NOT use this appliance if any part has been
under water. Immediately call a qualified service
technician to inspect the appliance and to
replace any part of the control system and any
gas control which has been under water.
An LP cylinder not connected for use should not
be stored in the vicinity of fire pit or any other
fire pit. Do not store spare LP cylinders within
10 feet of fire pit. LP cylinders must be stored
outdoors, out of reach of children. Do not store
a spare LP-gas cylinder under or near this fire pit.
Never fill the cylinder beyond 80 percent full.
Failure to follow these instructions exactly could
result in a fire causing death or serious injury.
While the fire pit is not in use, the gas must
be turned off at the supply cylinder. The fire
pit should be shut off and all supply valves (on
piping or on fuel cylinders) should be closed
in the event that the odor of unburned gas is
detected. Do not attempt to use the unit until
any gas leaks are fixed. Do not use the fire pit
if the burner fails to light or fails to remain
lit. Under such conditions, gas should be shut
off and fuel cylinders should be disconnected.
WARNING
DO NOT use this fire pit in a manner other
than its intended purpose. Not intended for
commercial use. Not intended to be installed
or used in or on a recreational vehicle or
oat. Keep a fire extinguisher accessible at
all times. The use of alcohol, prescription
or nonprescription drugs may impair the
consumer’s ability to properly assemble or
safely operate this fire pit. Solid fuels shall not
be burned in this gas fireplace.
DANGER
If you smell gas:
1. Shut off gas to the appliance.
2. Extinguish any open flame.
3. If odor continues, keep away from the appliance and
immediately call your gas supplier or fire department.
WARNING
Do not store or use gasoline or other liquids with flammable vapors in the
vicinity of this or any other appliance. An LP cylinder not connected for
use shall not be stored in the vicinity of this or any other appliance.
CARBON MONOXIDE HAZARD
This appliance can produce carbon monoxide which has no odor. Using it in
an enclosed space can kill you.
Never use this appliance in an enclosed space such as a camper, tent, car
or home.
WARNING
For Outdoor Use Only.
ASSEMBLY INSTRUCTIONS -
Step 1 - Place
firepit upside
down. Assemble 8
straps as shown
using the supplied
hardware. Finger
tighten all
hardware.
NOTE: Straps
should be
assembled on the
inside of the ring.
WARNING
STEP 1 - PLACE FIREPIT UPSIDE DOWN. ASSEMBLE 8 STRAPS AS SHOWN USING THE SUPPLIED HARDWARE. FINGER TIGHTEN ALL HARDWARE. NOTE: STRAPS SHOULD BE ASSEMBLED ON THE INSIDE OF THE RING
Step 2 - Assemble bottom
ring to 8 straps as shown
using the supplied
hardware. Finger tighten
all hardware.
Note: Straps should be
assembled on the inside
of the ring.
Step 3 - Stand the firepit
upright. Tighten all
hardware using the
supplied Allen Wrench.
STEP 2 - ASSEMBLE BOTTOM RING TO 8 STRAPS AS SHOWN USING THE SUPPLIED HARDWARE. FINGER TIGHTEN ALL HARDWARE. NOTE: STRAPS SHOULD BE ASSEMBLED ON THE INSIDE OF THE RING
STEP 3 - STAND THE FIREPIT UPRIGHT. TIGHTEN ALL HARDWARE USING THE SUPPLIED ALLEN WRENCH.
Step 4 - The
drum assembly
may have moved
during shipping.
Make sure burner
venturi tube is
positioned over
the valve as
shown.
Step 5 - Arrange the
20 pounds of lava rock
around the burner. For
a more realistic looking
flame arrange the rock to
cover most of the burner.
Be careful not to allow
any rock to come between
the ignitor electrode and
the burner.
0112-FP29TG-Instructions.indd 3-4 1/19/12 3:02 PM