Zephyr ZGE-E30AS - Manuel (Page 19)

17
SURFACE MAINTENANCE:
Periodically clean with hot soapy water and clean cotton cloth. Do not use corrosive or abrasive detergent
steel wool or scouring pads which will scratch and damage surface.
For heavier soil use liquid degreaser.
After cleaning it is recommended that you use non-abrasive stainless steel polish/cleaners to polish and buff
out the stainless luster and grain. Always scrub lightly with clean cotton cloth and with the grain.
Do not use any product containing chlorine bleach. Do not use “orange” cleaners.
Decorative Mesh Filters
The mesh fi lter installed by the factory is intended to fi lter out residue and grease from cooking. It need not
be replaced on a regular basis but is required to be kept clean.
Filter should be cleaned after every 30 hours of use or once a month.
Remove and clean by hand or in dishwasher on low heat. Spray degreasing detergent and leave to soak if
heavily soiled.
Dry fi lter and re-install before using hood.
Replacing Mesh Filter
Should fi lter wear out due to age and
prolonged use, replace with the following part
number:
Hood Model: Part No. Qty. to Order.
All ZGE Models 50200036 1
Replace any damaged fi lter that has punctured
or broken mesh or damaged frame.
To remove decorative mesh fi lter:
1. Pull down on handle.
2. Tilt fi lter down and remove from hood.
2
1
Maintenance –
Hood and Filter Cleaning