Zephyr ZGE-E30AS - Manuel (Page 18)

16
www.zephyronline.com
Features & Controls –
Remote Control (Optional)
FCC Caution: To assure continued compliance, any changes or modifi cations not expressly approved by the party
responsible for compliance could void the user’s authority to operate this equipment. This device complies with Part
15 of the FCC Rules. Operation is subject to the following two conditions. (1) This device may not cause harmful
interference, and (2) This device must accept any interference received, including interference that may cause
undesired operation.
Remote control is sold as an optional accessory. Purchase Zephyr part number: 14000005
This remote control may operate in humid environments, but not when placed on a wet surface.
Blower On/Speed Selection
By pressing , the blower is switched On. Press again to cycle through all
three blower speeds.
Blowers On/Hood Off
By pressing , the blowers will power on at the last speed setting. Press
again and the entire hood will power off, including lights.
Delay Off
Lights On/Dim/Off
Switch lights On by pressing once, again to dim and again to switch Off.
Blower On/
Speed Selection 1
1
2
3
4
Blower On/
Power Off
2
5 Min Delay Off 3 Lights On/Dim/Off 4
By pressing , the blower and lights will enter Delay Off mode. A dot will
appear in the lower right corner of the power pack display indicating the
function is on. The blower will change to speed 1 and shut down after 5
minutes.
A
-
+
SYNCHRONIZATION: To create a unique link between your range hood and remote control please follow the below steps:
1. With range hood off, press and hold the “lights” button on the range hood until the letter “F” shows on the display screen.
2. Press the “lights” button on the remote, the lights on the hood will turn on. The synchronization is complete.
REMOTE CONTROL FEATURES:
The RF remote control is equipped with a magnet for easy storage. The remote may be placed on any magnetic surface such
as a refrigerator or the Zephyr remote holder. Maximum remote control communication distance from power pack is 15 feet.
REMOTE CONTROL MAINTENANCE:
Clean the remote control using non abrasive detergents
Follow instructions below for replacing battery.
Using a small fl at head screwdriver, raise the cover of the battery door (A)
in order to access the battery compartment.
Remove the battery and replace with Type A23 12V.
Negative end of battery should face the spring inside the remote.
Replace battery door and recycle old battery.