White Rodgers 24A06G-1 - Manuel (Page 2)

2
W R
2-WIRE
HEATING
THERMOSTAT
TYPE 24A06 DUAL LEVEL TEMP
WHITE
BLACK
W/WHITE
STRIPE
RED
BIMETAL
HEATER #1
BIMETAL
HEATER #2
SWITCH #1
SWITCH #2
TRANSFORMER
HEATING
LOAD #1
R
E
D
B
L
A
C
K
B
L
U
E
BLACK W/RED STRIPE
RED W/BLACK STRIPE
L1 L2
LINE
L1 L2
LINE
HEATING
LOAD #2
9/32"
3 1/16"
9/16" 3 15/32" 9/32"
1 3/32"
4 15/16"
3 25/32"
9/16"
1 3/32"
2 1/8"
3/8"
7/32"
The Dual-Level Temp relay may be mounted in any position
without affecting it's performance.
It can be connected using the 1/2" male conduit hub and can
be mounted to any standard junction box or wiring compartment.
It can also be mounted using the two holes in the back of
the case. Location of the mounting holes may be simplified by
holding the control against the mounting surface and marking
the proper position for drilling the holes.
INSTALLATION
All wiring should be done in accordance with local and national electrical codes and ordinances.
If a wiring diagram is supplied with the heating equipment, fol-
low those instructions. If none is available, two diagrams are
presented which show different wiring methods for the Silent
Operator relay.
OPERATION
As the thermostat closes its contacts, bimetal heaters #1 and
#2 are energized. Approximately 45 seconds later, the warping
action of these heaters closes line voltage switches #1 and #2
to energize heating loads #1 and #2.
When the thermostat opens its contacts, bimetal heaters #1
and #2 cool for approximately 45 seconds before line voltage
switches #1 and #2 open to de-energize the heating loads.
WIRING AND OPERATION
NOTE
Use thermostat with a .4A fixed
heater, or set adjustable heater
in thermostat at .4A.
Connection Table
2-Wire Thermostat
(R & W)
Black w/White stripe and
White to terminal W. Red to
terminal R.
Power Input: Black & Blue
Heat Load 1: Red & L2
Heat Load 2: Black w/Red stripe & L2
1/2" STD CONDUIT HUB
WIRINg
Line Voltage
Line Voltage Field
Low Voltage
Low Voltage Field
Fig. 2. Using Two-wire Heating Thermostat to
Operate Two Separate Heating Loads
Fig. 1. Dimensions of Type 24A06 Dual Level Temp