Verilux VA04 - Manuel (Page 14)

14
Problem
The device is not working
correctly.
No light.
No radio or no sound.
Alarm doesn’t function.
Unplug from power, wait 30 seconds, then
plug in again.
• Press the
buttons.
• Replace the bulb if needed.
• Verify that the lamp icon is shown on the
display. If it is not shown, press down on
the lamp shade to turn on the lamp.
• If the Radio icon is not shown on the
display, press
Radio
.
• Increase volume.
• Attach the external antenna and vary the
antenna location for best reception.
• Verify the correct AM/PM setting.
• Verify that the alarm is activated (an alarm
is activated if both the alarm, AL1 or AL2,
and the time are shown).
Resetting the Rise & Shine
Troubleshooting
Your Rise & Shine ® uses a standard 60 Watt incandescent bulb.
To replace the bulb:
1. Make sure the lamp is unplugged and enough time has passed
to allow the bulb to cool.
2. Press the release button at the rear of the lamp shade and gently
pull the shade up to remove.
3. Unscrew the bulb and replace with a standard 60 Watt
incandescent bulb.
4. Align the shade and press down until the rear of the shade clicks
into place.
Note: Do not use a bulb rated higher than 60 watts.
Replacing the Bulb