Verilux VA04 - Manuel (Page 12)

12
To improve FM reception, you may wish to use the included external FM antenna.
Connecting the External FM Antenna:
1. Plug the 3.5 mm (1/8") plug of the FM antenna into the EXTERNAL ANTENNA
jack on the rear panel.
2. Straighten the antenna and position to establish optimum reception.
Setting the Alarm
Note: It is helpful to read through the entire section on
setting the alarm before you begin.
1. Press and hold the
Set
button for 3 seconds to enter
the clock setting mode. Press
Set
again to enter the
alarm setting mode.
• The alarm icons and sleep icon will flash on the left of the display. They
are, from top down: AL1 (Alarm 1), AL2 (Alarm 2) and Sleep . You may
set two alarms, each with a specific alarm time. You may also choose a
brightness level for the start of the sleep cycle.
2. Select AL1 or AL2 or by pressing the Back button or the Forward
button repeatedly. Press the
Set
button to confirm the desired selection. The
chosen icon will flash.
3. If AL1 or AL2 is chosen, press the Back button or the Forward
button repeatedly to adjust the alarm’s time. Press
Set
to confirm.
4. Press the Back button or the Forward button to select between FM
radio mode or natural soundcape mode and press the
Set
button to confirm.
• When the FM radio mode is selected, press the Back button or the
Forward button repeatedly to search for the desired radio station.
Then press “set” to the selected radio station.
• When the natural soundcape mode is selected, press the Back
button or the Forward button repeatedly to select bird, frog, river or
wave. Then press
Set
to confirm the desired soundcape.
5. The Audio icon will flash and the FM Radio or selected natural soundcape
will play. Press the Back button or the Forward button repeatedly to
adjust the alarm volume from 0 to 20. Press
Set
to confirm.
6. The light brightness icon will flash and the light will turn on. Press the Back
button or the Forward button on the right side repeatedly to adjust
the light brightness and press
Set
to confirm and exit.
Setting Sleep Cycle Brightness
1. Press and hold the
Set
button for 3 seconds to enter the clock setting mode.
Press
Set
again to enter the alarm setting mode.
Operating Instructions — continued