Quadra-Fire QFP44 - Manuel (Page 12)

Quadra-Fire • QFP44 • 4051-300 Rev M • 09/08 12
Remote Receiver
The remote receiver has a 3-position slide switch:
OFF/REMOTE/ON (see Figure 2.5).
NOTE: The remote receiver will only respond to the
transmitter when the 3-position slide button on the remote
receiver is in the Remote position. If the system does
not respond to the transmitter on initial use, see section
Matching Security Codes.
OFF-REMOTE-ON GROUND VALVE
FLAME
CONTROL
LEARN
Receptacle on back
3-position switch
Figure 2.5 Remote Receiver
• With the slide switch in the ON position, the system is
on.
• With the slide switch in the REMOTE position, the system
only operates if the remote receiver receives commands
from the transmitter.
• With the slide switch in the OFF position, the system is
off.
NOTE: The slide switch should be placed in the OFF
position if you will be away from your home for an extended
period of time. Placing the switch in the OFF position also
functions as a safety “lock out” by turning the system off
and rendering the remote receiver inoperative.
Transmitter
Important: Before operating remote control, transmitter
and receiver must have matching security codes. See
section ‘Matching Security Codes’.
Important: Review ‘Thermo-Updating/Communication-
Safety Features’ under ‘Transmitter Safety Features’
section. Communication Safety features shut down the
fireplace system when a potentially unsafe condition
exists.
Important: Review ‘Auto Shutdown’ section. This safety
feature shuts down the ¿ replace after 9 hours of continuous
operation, in ON mode only. Important: New or fully charged
batteries are essential for proper operation of the multi-
function transmitter. The transmitter operates on 2 AAA-size
1.5V batteries. Use Alkaline batteries for longer battery life
and maximum operational performance.
Insert 2 AAA-size 1.5V batteries into the battery compart-
ment on the back of the transmitter. When the batteries
are correctly inserted, the screen will display numbers
(see Figure 2.6 for LCD Display Screen).
NOTE: If the transmitter is activated from a very cold
condition it may be necessary to allow the transmitter to
stabilize to room temperature (could take up to 15 minutes)
before accurate room temperatures are displayed on the
screen.
NOTE: LCD screen is equipped with a “backlite” for
easier viewing of LCD screen. Backlite illuminates when
a function button is depressed. After 5 seconds elapses,
LCD screen will return to its normal state.