Sylvania ST88244 - Manuel (Page 5)

Bracket
(not included)
5
Installing the Base
▼
On a Desk Top
1. Plug one end of the supplied modular
cord into the TEL LINE jack on the back
of the base.
2. Insert the
supplied AC
adapter’s barrel
plug into the DC
IN 9V jack on the
back of the base
and route the
adapter’s cord
through the strain
relief slot on the base.
3. Plug the other end of the modular cord
into a modular phone line jack.
4. Plug the adapter into a standard
AC outlet.
CAUTION:
You must use a Class 2 power source that supplies
9V DC and delivers at least 210 mA. Its center tip
must be set to positive and its plug must fit the
phone’s
DC IN 9V jack. The supplied adapter
meets these specifications. Using an adapter that
does not meet these specifications could damage
the phone or the adapter.
▼
On a Wall Plate or Wall
To mount the phone directly on a wall, you
need two screws (not supplied) with heads
that fit into the keyhole slots on the base.
Drill two holes 3 15/16 inches apart. Thread
a screw into each hole, letting the heads
extend about 1/8 inch.
1. Insert the two of upper tabs of the
optional bracket (not included) into the
base’s upper tab slots.
Then slide down the bracket so that two
of the lower tabs would be inserted into
the lower slots.
2. Plug one end of
the supplied
modular cord
into the TEL
LINE jack on the
base’s back.
3. Plug the
supplied AC
adapter's barrel
plug into the DC
IN 9V jack.
4. Route the adapter and modular cords
through the bracket’s grooves.
5. For a wall plate, align the bracket’s
keyhole slots with the wall plate
studs and slide the base downward
to secure it.
For direct wall mounting, align the
bracket’s keyhole slots with the mounting
screws and slide the base downward to
secure it.
6. Plug the adapter into a standard AC
outlet. And plug the modular cord’s other
end into a modular phone line jack.
Installing the Optional
Beltclip (not included)
▼ To attach the beltclip
Insert the beltclip into the holes on each
side of the handset. Press down until it
clicks.
▼ To remove the beltclip
Pull both sides of the beltclip to release the
tabs from the holes.
TEL LINE
DC IN 9V
TEL LINE
DC IN 9V
UP043DH (ST88244) resize 9/15/04 2:12 PM Page 5