Installation, Charging the battery pack, Selecting a location – Sylvania ST88244 Manuel d'utilisation

Page 4: Choose the dialing mode

Advertising
background image

4

Charging the Battery Pack

The rechargeable Nickel-Cadmium battery
pack must be fully charged before using
your phone for the first time. Before
plugging the phone line into your new
phone, you must charge the battery for
approximately 15-20 hours without
interruption.

1. Remove the handset

battery cover.

2. Plug the battery’s cable into the handset.

NOTE: The plastic connectors will fit together only

one way. Make sure the battery’s
connector is properly aligned. Use only the
battery pack (model BT-905) supplied with
your phone.

3. Replace the battery cover.

Charging the Handset

Place the handset on the
base to charge.

Low Battery Indicator

When the battery
pack in the handset
is low and needs to
be charged, the
TALK/BATT LOW
LED flashes every
3 seconds.

If this occurs while you are on the phone,
you will hear a tone. Complete your call as
quickly as possible, and return the handset
to the base for charging.

Cleaning the Battery Contacts

To maintain a good
charge, it is important
to clean all battery
contacts on the
handset about once a
month. Use a damp
cloth.
Do not use any
liquids or solvents.

Selecting a Location

Before choosing a location for your new
phone, read the “Important Safety
Instructions”.

NOTE: • Do not place the power cord in an area

where it may create a trip hazard or
become chafed and create a fire or
electrical hazard.

• If your home has specially wired alarm

equipment connected to the telephone
line, be sure that installing the system
does not disable your alarm equipment.

If you have questions about what will
disable your alarm equipment, contact
your telephone company or a
qualified installer.

Choose the Dialing Mode

1. Press and hold FLASH until you hear a

confirmation tone.

2. To set the dial mode for pulse dialing,

press #.

Or to set the dial mode for tone dialing,
press

*

/TONE. A confirmation tone

sounds to indicate the setting is
complete.

NOTE: Make sure your battery pack is fully

charged before choosing the dial mode.

Installation

3

2

1

Red

Red

Wire

Black

Wire

Black

CHARGE /
IN USE LED

Contacts

UP043DH (ST88244) resize 3/3/04 5:24 PM Page 4

Advertising