ROTEL RSP-1069 - Manuel (Page 47)

47 English
• Component Video output at 720p or 1080i
may not be available if the source signal
includes HDCP copy protection.
• HDMI cables must be 5 meters or less in
length.
OSD menus are not displayed on TV
Monitor.
• In some PAL systems, the menus may not
be displayed unless there is an active
video signal.
Video and Audio do not match.
• Check that the proper video source is se-
lected for each input.
• Check that the group delay (lip-synch)
setting is not misadjusted.
Clicking or popping sounds when
switching inputs.
• The unit uses relay switching to preserve
maximum sound quality. The mechanical
clicking of the relays is normal.
• During switching, it may take a split sec-
ond for digital signals to be recognized
and properly decoded. Rapid repeated
switching between inputs or settings can
result in clicks or pops from the speak-
ers as the unit attempts to lock on to the
rapidly changing signals. This causes no
harm.
Controls do not operate.
• Make sure that fresh batteries are installed
in the remote.
• Make sure that the IR sensor on the front
panel is not blocked. Aim the remote at
the sensor.
• Make sure the sensor is not receiving strong
IR light (sunlight, halogen lighting, etc.)
• Unplug the unit from the AC outlet, wait 30
seconds, and plug it back in to reset.
No video from Zones 2, 3, or 4
• Check ZONE SETUP configuration and
zone video input setting as assigned and
make sure that a Composite source is con-
nected.
Specifications
Audio
Total Harmonic Distortion
<0.008%
Intermodulation Distortion (60 Hz:7 kHz)
<0.008%
Frequency Response
10 Hz – 120 kHz, ±3dB (analog bypass)
10 Hz – 95 kHz, ±3dB (digital input)
Signal to Noise Ratio (IHF A-weighted)
95dB (analog bypass)
92dB (Dolby Digital, dts) 0dBFs
Input Sensitivity/Impedance
Line Level: 200 mV/100K ohms
Preamp Output Level/Output Impedance
1.0 V / 1K ohms
Contour (LF/HF)
±6dB at 50 Hz/15 kHz
Decodable Digital Input Signals
Dolby Digital, Dolby Digital EX, DTS, DTS-ES,
DTS 96/24, DTS ES 96/24, LPCM (up to 192K),
HDCD, DVD-A (HDMI HD ONLY)
Video
Input Resolutions
480i/576i
480p/576p
720p
1080i
1080p (HDMI only)
Output Resolutions
480i/576i (Composite, S-Video only)
480p/576p
720p
1080i
1080p (HDMI only)
HDMI Input/Output:
Version 1.1
Signal to Noise Ratio
45dB
Input Impedance
75 ohms
Output Impedance
75 ohms
Output Level
1.0 volt
General
Power Consumption:
80 watts
4.7 watts (standby)