Napoleon Fireplaces GSS36N - Manuel (Page 7)

7
W415-0369 / E / 02.16.07
IT IS HIGHLY RECOMMENDED TO PROTECT
THE LOGS FROM MOISTURE.
COVER THE FIREBOX WHEN NOT IN USE.
PHAZER TM logs are exclusive to NAPOLEON® Fireplaces,
and provide a unique and realistic glowing effect that is dif-
ferent in every installation.
Log colours
may vary. During the initial use of the fi replace,
the colours will become more uniform as colour pigments
burn in during the heat activated curing process.
1. Place the back log (#1) onto the log
support tray and in front of the tabs. The
tabs maintain an air space between the
log and fi rebox back to facilitate combus-
tion air fl ow. Ensure that the back of the
log rests against the brackets on the back
wall of the fi rebox.
2. Move the two small logs (#2 & #3) into position, lining up
the studs located on the burner with the holes on the bottom
of the logs. Ensure that the small logs sit fl at on the burner.
3. Place the bottom of the left crossover log (#4) against
the left fi rebox side and pulled forward to the grate.
The top of the log should rest in the pocket on the back log.
4. Position the notch located on the end of the center log
(#5) against the middle grate post with the other end of the
log resting in the pocket of the left crossover log.
5. Place the bottom of the right crossover log (#6) against
the right fi rebox side and pulled forward to the grate. The top
of the log should rest in the pocket provided on the center
log (#5).
Blocked burner ports can cause an incorrect fl ame pattern,
carbon deposits and delayed ignition. PHAZER
TM logs glow
when exposed to direct fl ame.PHAZER TM logs available from
your NAPOLEON® dealer.
FINISHING
LOG PLACEMENT
FIGURE 11a-d
IMPORTANT
SIDEVIEW
TAB