Peg-Perego ECE R44 - Manual (Page 22)

back of the seat, as shown in the figure.
30• Check to make sure that the seat belt is taut and
securely fastened, for maximum safety.
• To remove the child car seat from the vehicle,
remove the vehicle seat belt from the back of the
child seat. Pull the handle until it clicks into place
in an upright position, and unfasten the child
seat from its base. Leave the base mounted in the
vehicle, ready for use.
FASTENING THE CHILD CAR SEAT IN THE VEHICLE
WITHOUT ITS BASE
31• Only when it is necessary to place the child car
seat in the vehicle without its base, unbutton the
two side tabs, and place them to the inside.
32• Place the car seat with your child in it on the
vehicle seat, and fasten the safety belt.
• The child car seat must be positioned backwards
in relation to the direction of the vehicle.
• The correct tilt for the child seat is parallel to the
ground. If necessary, use rolled-up towels under
the child seat to obtain the correct position.
33• Slip the vehicle seat belt through the two side
slots on the child seat, making sure that the belt
remains taut.
34• Fasten the vehicle seat belt buckle, as shown in
the figure.
35• With the child car seat mounted in the vehicle, the
handle on the seat must be lowered all the way
against the back of the vehicle seat, as shown
in the figure. Push the handle until it clicks into
place.
36• Pass the vehicle seat belt around the backrest of
the child seat.
37• Slip the seat belt through the slot on the back of
the child seat, as shown in the figure.
38• Check to make sure that the seat belt is taut and
securely fastened, for maximum safety.
CLEANING & MAINTENANCE
Your product requires only minimal maintenance.
Cleaning and maintenance operations must be
performed only by adults.
• Be sure to keep all moving parts clean, lubricating
them with light oil if necessary.
• Regularly clean the plastic parts with a damp cloth.
Do not use solvents or similar products.
• Brush the fabric parts to remove dust.
• Do not use solvents or similar products to clean the
polystyrene bumper.
• Protect the product against smog, water, rain and
snow. Continued and extended exposure to sunlight
can change the colours of many materials.
• Store the product in a dry area.
SAFETY
ATTENTION
• IMPORTANT WARNING: IT IS FORBIDDEN TO MOUNT
THE CHILD CAR SEAT ON A SEAT WITH AN AIR BAG
SYSTEM INSTALLED.
• THIS GROUP 0+ CHILD SAFETY CAR SEAT MUST
ALWAYS BE INSTALLED FACING BACKWARDS IN
RELATION TO THE DIRECTION THE CAR TRAVELS.
• ALWAYS USE THE CHILD CAR SEAT SAFETY BELTS,
AND CHECK TO MAKE SURE THAT THE CHILD DOES
NOT UNLATCH THE BELT BY HIMSELF.
• THIS RECLINED CRADLE IS NOT INTENDED FOR
PROLONGED PERIODS OF SLEEPING.
• TO AVOID DANGER OF THE CHILD'S FALLING OUT OF
THE CAR SEAT, THE SAFETY BELT MUST ALWAYS BE
USED TO FASTEN THE CHILD IN THE SEAT.
• WHEN ATTACHING THE BASE AND THE CHILD CAR
SEAT, PASS THE THREE-POINT CAR SEAT BELT
THROUGH THE SPECIAL SLITS.
• THIS CAR SEAT MAY BE MOUNTED ON THE CAR