Peg-Perego FICA0401I22 Primo Viaggio - Manuel (Page 23)

VEHICLE SEAT BELTS
Primo Viaggio is designed for vehicles
equipped with a lap belt or shoulder/lap
belt. However, there may be different
designs. Only the most popular are
reviewed here. Please read your vehicle
owner’s manual on use of child passenger
seats.
12•If your vehicle is equipped with a seat
belt that slides freely through the latch
plate, you must use the locking clip
(located on the car seat base) because
the base will not be firmly secured to
the seat and will slide in the event of a
crash. To put the plate on the belt, first
install the base, then hold the lap and
shoulder strap together close to the
latch and unbuckle. At the end of this
operation, it may be necessary to
further adjust the base inclination with
the screw knob. Always check that the
ball in the side indicator is in the green
area.
13•Keeping the two straps in hand, put
the locking clip as shown in the picture
keeping the locking clip position away
from the latch by 1/2 inch approx
(1cm).
14•Manually adjustable lap belt: if after
locking, the latch plate becomes loose,
due to a wrong angle, flip the plate
over and buckle again. Test installation
before use.
15•Lap belt with retractor: if you have
an Automatic Locking Retractor, let the
belt pass through the base slot, buckle
and tighten until the retractor locks.
If you have an Emergency Locking
Retractor DO NOT USE to fit your car seat.
(to check the retractor: extend the belt all
the way out, allow it to retract by about 6
inches and then pull out again; if it locks
you have an Automatic Retractor, if you
can pull freely, then you have an
Emergency Retractor).
23
PrimoViagg-CA_FICA0401I22 7-05-2004 15:04 Pagina 23