Panasonic K10059 - Manuel (Page 27)

27
Security Codes & Authority Levels
Deleting User Code
You can delete the user code and programmed attributes except assigned partition.
Refer to “Delete User Code” on page 31 in the 3000EN Security Systems User’s Guide.
While the security system is armed, you can not turn on this function. To turn
on, disarm the security system (p. 12).
Make sure all perimeter doors and windows are closed and is
displayed.
: Press the soft key ( ), and follow steps 2 to 6 above, using
the cordless handset. Press the soft key ( ), then press [OFF] to go to
the standby mode.
1 Press [ADT].
2 Scroll to “OTHER FUNCTIONS” by pressing [d]
or [B], then press [g].
3 Scroll to “USER CODES” by pressing [d] or [B],
then press [g].
4 Scroll to “DEL. USER CODE” by pressing [d]
or [B], then press [g].
5 Enter the security code for system master.
6 Enter the user number of 2 digits.
(Ex. To delete user number 8, enter “08”.)
7 Press [g] (ENTER).
• If a confirmation tone (one beep) is not heard, you
entered the wrong security code in step 5 or wrong
user number in step 6. The setting is not saved.
Try again from step 4.
8 Press [STOP] to go to the standby mode.
READY
Base Unit
OTHER FUNCTIONS
g
USER CODES
g
DEL. USER CODE
g
ENTER CODE
----
Enter User #
-,-
Enter User #
0,8
=ENTER READY g
Example
Handset
ADT
OK
SecurityPhone.book 27 ページ ２００４年７月２１日 水曜日 午後６時５８分