Panasonic K10059 - Manuel (Page 10)

Arming the System
10
Setting the Night-Stay mode
When you want to get more increased security than the Stay mode, select this
mode.
When you set the Night-Stay mode,
— the perimeter zones and pre-selected interior sensors (programmed by your
installer) are armed, and
— if the protected perimeter windows and doors are opened or interior zones are
violated, an alarm sounds immediately.
: Press the soft key ( ), and follow steps 2 to 4 above, using
the cordless handset. Press [OFF] to go to the standby mode.
• To exit the menu, press [STOP] or [OFF].
To confirm the security mode you set, press [ADT] in the standby mode.
1 Press [ADT].
2 Press [g] at “ARM”.
3 Scroll to “Night-Stay” by pressing [d] or
[B], then press [g].
4 Enter your security code.
• If you entered the wrong security code, the phone
will go back to the previous display. Try again from
step 2.
• The armed NIGHT-STAY message is displayed.
5 Press [STOP] to go to the standby mode.
IMPORTANT:
When the Night-Stay mode is on, the selected interior zones are armed and
cause an alarm if anyone enters those areas (e.g., waking in the middle of the
night). To avoid sounding an alarm, you must disarm the system before any
activity takes place in those interior zones
Base Unit
ARM
g
Night-Stay
g
ENTER CODE
----
;;;
NIGHT-STAY
;;;
You may exit now
Example
Handset
ADT
SecurityPhone.book 10 ページ ２００４年７月２１日 水曜日 午後６時５８分