Life Fitness T5i Manuel d'utilisation
Page 30
29
6.3
H
OW
T
O
A
DJUST
A
ND
T
ENSION
T
HE
S
TRIDING
B
ELT
O
N
T
HE
L
IFE
F
ITNESS
T
READMILL
Do not move treadmill or place hands under treadmill while it is plugged into an electrical outlet!
Tool required: 5/16" hex key wrench
T
HE
B
ELT
T
ENSIONING
B
OLTS
The Life Fitness treadmill has access holes in the rear roller guards, which allow access to the tensioning bolts.
These tensioning bolts make it possible to adjust tracking and centering of the striding belt (A) without removing the
guards.
NOTE: It is extremely important that the treadmill be correctly leveled prior to any tracking adjustments. An
unstable unit may cause striding belt misalignment. See "How To Stabilize the Life Fitness Treadmill" in the "Set
Up" section prior to attempting any rear roller adjustments.
Before proceeding, it is helpful to visualize the REAR ROLLER (B) pivot point (C). Each adjustment made to one
side of the ROLLER must be met with an equal and opposite adjustment (D) to the other side of the ROLLER to
maintain an ideal belt tension at the pivot point.
T
RACKING
(C
ENTERING
) A
N
E
XISTING
O
R
N
EW
S
TRIDING
B
ELT
1
Locate the two access holes to the belt tensioning bolts on each of the rear roller guards.
2
Stand on the sides of the treadmill and straddle the belt, not standing on it. Enter the Manual Workout and set
the belt speed to run at 4.0 mph (6,4 kph).
3
If the striding belt has moved to the right, turn the right tension bolt 1/4 turn clockwise with provided ¼” Allen
wrench, and then turn the left tension bolt 1/4 turn counter-clockwise to start striding belt tracking back to center
of roller.
4
If the striding belt has moved to the left, turn the left tension bolt 1/4 turn clockwise and then turn the right
tension bolt 1/4 turn counter-clockwise to start striding belt tracking back to center of roller. Repeat adjustments
until striding belt appears centered. Allow machine to continue running for several minutes to observe if tracking
remains stabilized.
NOTE: Do not exceed one full turn of the adjusting screws in either direction. If after one full turn the belt does not
track properly, contact Customer Support Services. The phone numbers are listed in "How to Obtain Product
Service."
A
B
C
D
D