Lennox Hearth ELITE VISN-25/35 - Manuel (Page 12)

12
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
7. Place the left log on burner supports with the charred surface facing
up. The left log will only fit on the burner supports in one direction.
8. Place embers around the perimeter of the burner and sparingly in field
of burner. Do not block air holes on the burner.
Brick Panel And Log Set Installation
If logs are not installed according to the log installation instruc-
tions, flame impingement and improper combustion could
occur and result in soot and/or excessive production of carbon
monoxide (CO), a colorless, odorless, toxic gas.
The size and position of the log set is critical to achieve a safe,
reliable and attractive flame pattern. Any attempt to use a differ-
ent log set in the fireplace will void the warranty and will result
in incomplete com- bustion, sooting and poor flame quality.
CAUTION: If the logs are not properly installed, your appliance
will not function correctly.
Parts list: rear log, right log, left log, center log, brick panel (packaged
separately)
1. Remove the logs from the box and carefully unwrap them. The logs
are fragile, so handle them with care.
2. Remove the brick retainer bracket from the upper left corner inside
the stove.
Log Inserts
5. Place ember material (rockwool) over ports. The ember material can
be placed to obscure air holes, but do not cover the air holes.
* Fifty percent or less of ember material (rockwool) supplied should
be used in LP installations. Too much ember material will result
in tall sooty flames.
6. The right front log (positioned with the black charred surface toward
the front) should be placed on the peg protruding from the right side
of the stove.
Right Log
Embers Left Log
Brick
Retainer
3. Install the brick panel and replace the brick retainer bracket.
4. Place the rear log on the back log supports. The charred surface of
the log should face the front.
Figure 8
Figure 9
Figure 10
Figure 12
Figure 11