La Crosse Technology WS-9626U-IT - Manuel (Page 12)

11
8. In order to ensure sufficient 915 MHz transmission however, this should under good conditions
be a distance no more than 100 meters between the final position of the Weather Station and
the transmitter (see notes on “Mounting” and “915 MHz Reception”).
Note:
If the signal reception is not successful on the first frequency (915MHz) for 45 seconds, the frequency
is changed to 920MHz and the learning is tried another 45 seconds. If still not successful the reception
is tried for 45 seconds on 910MHz. This will also be done for re-synchronization.
IMPORTANT:
• Transmission problems will arise if the setting for additional sensors is not followed as described
above. Should transmission problems occur, it is necessary to remove the batteries from all units
and start again the set-up from step 1.
• The indoor receiver registers the temperature by default in Farenheit (°F), but user can
manually set to Celsius (°C) ONLY after the initial set-up is complete as instructed in the
manual. After the LCD shows the temperature readings from the three outdoor
transmitters, user may set the temperature unit to °C (See Manual Settings below).